Care and maintenance
Descaling procedure
Warning: For safety reasons, the descaling process
cannot be interrupted and it takes about 45 minutes.
The appliance can be descaled with the appliance door
open or closed. The appliance must be in idle state prior
to starting the descaling cycle.
To run a descaling cycle proceed as follows:
1. Press the “-” and “+” keys at the same time for 5
seconds. The display shows “CAL” and there is an
intermittent beep. If you wish to cancel the descale
process at this stage Press the “On/Off” key .
2. Press the “OK” key to start the descaling function.
3. When the display shows “0.5L”, Short beeps are
emitted. Remove the water tank.
4. Pour 0,5 litres of an adequate descaling solution into
the water tank and put the water tank back.
5. Press the “OK” key . The Descale cycle is initiated
and takes about 30 minutes.
The descaling process is silent and during this process
the display shows continuously "0.5L" (without
blinking).
6. When the display shows “1.0L” flashing and the oven
emits a beep, remove and empty the water tank.
7. Fill the water tank with 1,0 litres of cold water and put
the water tank back.
8. Press the “OK” key . The first rinsing cycle starts.
9- When the display again shows “1.0L” flashing and the
oven emits a new beep, remove and empty the water
tank.
10. Fill the water tank with 1.0 litres of cold water and put
the water tank back.
11. Press the “OK” key . The second rinsing cycle starts.
12. When the rinsing cycle has finished the display shows
“End”. The message “DEP” will be displayed until the
water tank is removed.
13. Remove, empty and dry the water tank.
