661111
9
Zoom out
Zoom in
Previous page
1/10
Next page
Cleaning your oven
Do not clean the oven when it is switched on.
The inside of the oven can be easily cleaned with a wet cloth and oven clea-
ner (always follow cleaner’s instructions).
As a safety measure, before you start cleaning the oven, make sure the
electrical supply is switched off. You should clean the oven when it is cold.
Do not leave acid or alkaline residues (lemon juice, vinegar, salt, tomato,
etc) on the enamelled surfaces. Avoid abrasive cleaning products as theser
may permanently damage the enamelled surfaces.
Regenerating the ökotherm
®
-converter
Heat the empty oven by hot air convection at maximum temperature for
60 min.
Changing the oven cavity light bulb
Caution:
Disconnect oven from mains supply before removing oven bulb.
If the oven light fails:
1. Turn off the oven by switching the oven selector to 0, switch off at the
cooker point.
2. When the oven is cool, reach back and upwards inside the oven. The
bulb is situated in the top left corner in both ovens.
3. Unscrew the light glass cover, replace the bulb with a new one of the
same specification and screw the cover back until it is hand tight.
Note: Oven bulb replacement is not covered by your guarantee.
Other bulbs cannot be changed by yourself and should be replaced
by a qualified electrical engineer. Bulbs other than the oven bulb are
covered by the guarantee.
Important! Warning-ovens get hot.
Keep children away from this appliance.
Troubleshooting
Repairs may only be carried out by a qualified technician!
Check first whether you have made an error in operating the controls. You
can mend some faults yourself, or call the service centre to carry out the re-
pairs, as indicated.
Check the following points:
1. Check whether the fuse at the main fuse box is still working.
2. Check that the timer is set to manual.
3. If your appliance is still not working, call the after-sales-service.
Fault Cause Remedy
Both upper oven
and lower oven do
not heat up
Fuse defect Check or replace fuse
Oven does not heat
up
Oven temperature
control or function
switch has not been
switched on
Set oven temperature
control or function switch
as required
Oven light does not
work
Light bulb defect Replace the light bulb
Oven door glass is
broken
Switch off cooker, call
service centre
Strong smells from
oven inspite of öko-
therm
catalyst
ökotherm
catalyst
must be regenerated
Pre-heat empty oven with
hot air to maximal
temperature
Strong vinegar smell
when preparing
Sour doughs,
yeast doughs,
dishes with alcohol
Unavoidable odours
Fruit juice or protein
stains on enamelled
parts
Moist cake or meat
juices
Harmless changes in the
enamel, cannot be
remedied
Nameplate
is located on the right-hand side strip and is visible when the oven door is
open. Please note the following information for contacting the service centre:
F-number
Model designation oven
EEB 9640.0 9
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kuppersbusch EEB 9640.0 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kuppersbusch EEB 9640.0 in the language / languages: English as an attachment in your email.

The manual is 0,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info