When used in freezer units, the sensor units must be adjusted to the ambient temperature
before commissioning. Otherwise, undefined fault messages will be shown, which will
disappear once the sensor units are acclimatised. Only then will your system be ready to run!
1.4System configuration
The sensor unit is installed in all spaces at risk (cellars/cold rooms, storage areas and holding spaces for gas cylinders, freezer units, etc.).
The warning unit/add-on module must be installed directly in front of the hazard area.The warning unitand sensor unit are connected to each other by means
of a distributor.
The switching unit switches on an extraction unit or other power consumption device in the event of an alarm. The signal unit secures the hazard area from
further access.
The warning unit must be installed immediately in front of the entrance to the hazard
area! Where there are multiple entrances to the hazard area, a signal unit and/or
additional alarm unit must be installed in front of each additional entrance!
a)Installation in a dispensing system
b)CO2 CONTROL add-on module installation for a CO2 cooling system
In grocery stores, cold rooms, freezer rooms and machine rooms are mostly secured with CO2 CONTROL AM. Alarm and fault messages are controlled at the
refrigeration control system. Alarms are acknowledged directly in a decentralised manner on the add-on module.
Counter
Additional signal unit can be installed directly on the counter
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Kundo xT CO2 Control at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Kundo xT CO2 Control in the language / languages: English as an attachment in your email.
The manual is 1,55 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
