ENGLISH
18
DRIVING INSTRUCTIONS »
Check the following before each start
When you start off, the motorcycle must be in perfect technical condition.
For safety reasons, you should make a habit of performing an overall check
of your motorcycle before each start.
The following checks should be performed:
1 CHECK THE OIL LEVEL
Insufficient oil results in premature wear and consequently to engine
damage.
2 FUEL
Check that there is sufficient fuel in the tank; when closing the filler cap,
check that the tank venting hose is free of kinks.
3 CHAIN
A loose chain can fall from the chain wheels; an extremely worn chain can
tear, and insufficient lubrication can result in unnecessary wear to the chain
and chain wheels. Excessive tensioning of the chain will put additional
load on the components of the secondary drivetrain (chain, bearings of
transmission and rear wheel). Aside from resulting in premature wear, if
worst comes to worst the chain may rupture or the countershaft of the
transmission may break.
4 TIRES
Check for damaged tires. Tires showing cuts or dents must be replaced.
The tread depth must comply with the legal regulations. Also check the
air pressure. Insufficient tread and incorrect air pressure deteriorate the
driving performance.
5 BRAKES
Check correct functioning of the braking system. Check for sufficient
brake fluid in the reservoir. The reservoirs have been designed in such a
way that brake fluid does not need to be refilled even when the brake pads
are worn. If the level of brake fluid falls below the minimum value, this
indicates a leak in the braking system or completely worn out brake pads.
Arrange for the braking system to be checked by a KTM specialist, as com-
plete failure of the braking system can be avoided.
Also check the state of the brake hose and the thickness of the brake
linings.
Check free travel at the hand brake lever and foot brake lever.
6 CABLES
Check correct setting and easy running of all control cables.
7 COOLING FLUID
Check the level of the cooling fluid when the engine is cold.
8 ELECTRICAL SYSTEM
Check correct functioning of headlamps, tail-lights, brake lights, indica-
tors, control lamps and horn while the engine is running.
9 LUGGAGE
If you are taking luggage with you, check that this is securely fastened.
A
B
1
Starting when the engine is cold
1 Open the fuel tap [1].
2 Swing up the side stand or center stand.
3 Put the gear in neutral.
4 Operate the choke [2].
5 Leave throttle closed and kick the kickstarter briskly ALL THE WAY or actu-
ate the E-starter.
– IF YOU WANT TO START THE ENGINE, MAKE SURE THAT YOU ALWAYS PUT ON
STURDY MOTORCYCLE BOOTS IN ORDER TO AVOID INJURIES. YOU MIGHT SLIP
OFF THE KICKSTARTER, OR THE ENGINE MAY KICK BACK AND PROPEL YOUR
FOOT UPWARD WITH GREAT FORCE.
