361592

Krups xp 4000 Manual

13
Zoom out
Zoom in
Previous page
1/88
Next page
16
• Then turn the selector to the setting (9)
(10).
• At the beginning, there is a time of pre
brewing.
• When the cups are full, reset the selector to
the O setting.
• Remove the filter holder and the filter from
the machine, and take out the coffee
grounds (14).
The filter can be refilled to make more
espressos.
. WITH THE SPECIAL «ESE» FILTER
The E.S.E. system was designed for making
Italian-style “espresso ristreto” (squeezed).
The amount of coffee is 35 ml and the water
should take 20 seconds to run through.
«ESE», which stands for «Easy Serving
Espresso» , is a selected measure of coffee,
ground and pressed between two filter papers
making it ready for use. This system makes it
easy for you to prepare your espresso because
you avoid the measurement and tamping
down operations and it also makes it easier
for you to clean the appliance.
We do not intend, or recommend, that
the ESE servings are used for making a
long coffee.
We recommend that you take care, when
handling and storing the ESE servings, that
they do not become deformed.
For best results, we recommend that you pre-
heat the accessories (filter holder, filter and
cups) without any coffee. To do this, make as
above espresso function.
. Preparing an espresso:
• Fill the water tank (1) (2) (3) and start the
appliance (4).
• Place the ESE serving in the ESE filter (18).
Tear excess paper from pod at perforated
edge. Place the ESE pod with the RED
MARKING FACE DOWN (bend the paper
corners down).
• Take care to put all the paper inside the filter
or you will have some drips.
Placing the ESE pod correctly will create a
richer, thicker crema.
• Put the filter holder in place (6) (7) (8) by
pressing it firmly to the right.
• Once the appliance reaches the correct
temperature, the orange temperature
control light will go out.
•
Then turn the selector to the setting (9).
•
At the beginning, there is a time of pre-
brewing.
• When the recommended quantity of coffee
has been reached (35 ml) turn the selector
to the O position.
• Remove the filter holder from the brewing
head and throw away the used measure.
2. STEAM FUNCTION
The tapping noise which occurs while steam is
being produced comes from the intermittent
regulation of the pump and has no effect on
the proper working of the appliance.
If you wish to make an espresso immediately
after steam, the appliance must first be
allowed to cool down in order to achieve the
correct temperature for preparing an espresso.
• The appliance automatically cools down
when turning the selector to the O setting.
When cooling down the orange indicator
light comes on and hot water goes into drip
tray. When correct temperature is reached,
the appliance is running on espresso cycle.
Beware: during and after use of the machine,
the metallic parts of the cappuccino accessory
can become very hot.
. Using the cappuccino accessory
The cappuccino accessory makes it easy to
produce frothy milk for making a cappuccino.
• Fill the water tank (1) (2) (3) and start the
appliance (4).
• Move the cappucino accessory to the
exterior of the appliance.
• Pour about 100 ml (3 oz) of very fresh, very
cold milk into a small, narrow container with
a capacity of about 0.5 litres which will fit
under the cappuccino accessory. The milk
and its container must be well chilled (so it is
not advisable to run the container under hot
water before frothing the milk).
XP 4000/4020 eur Lta. PM6.5 30/11/04, 15:5316
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Krups xp 4000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Krups xp 4000 in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 1,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Krups xp 4000

Krups xp 4000 User Manual - English - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info