480410
18
Zoom out
Zoom in
Previous page
1/50
Next page
18
Each time you make coffee or steam, the
heating system expands (emitting a whistle)
and the water which escapes then runs into
the drip tray.
After about 20 cups of coffee, the drip tray
must be emptied and clean. Remove the grid
and clean it too (23).
Before replacing the tray and grid, make
sure that the plastic part par is correctly
positioned at the back of the drip tray.
The capsule holder can be cleaned as per the
rinsing operatin and under the tap. The
capsule holder can be cleaned in the
dishwasher and must be cleaned at least once
a week.
Clean the steam nozzle using a damp
sponge after each use.
If the nozzle is blocked, unscrew the pipe using
a coin and unblock the nozzle with a needle.
When replacing the pipe, take care that the
rubber seal is correctly positioned (24).
To clean the «cappuccino » accessory :
Seperate parts A and C from the metal stem
B (25).
Wash all 3 parts in warm water.
If the small opening at the end of A is
blocked, you can unlock it with a needle.
For more thorough cleaning, the capsule cage
can be removed :
Unplug the appliance, remove the water
tank and the drip tray.
Place the machine up-side down (26).
Unscrew the capsule cage with the special
key, anti-clockwise (27) (28).
Rinse the capsule cage thoroughly under
running water and clean the two perfora-
tions using the unblocking tool (29).
Be careful when using the unblocking
tool, as careless handling could cause
injury.
Blow in the direction indicated by the arrow
(from bottom to top) in order to clear the
from any impurity (30).
Clean the water inlet of the capsule cage
using the special mesh found on the end of
the unblocking tool (delivered with the
machine) (31).
Clean the two perforations again using the
unblocking tool.
After cleaning put the capsule cage into
special hexagonal key. Make sure that the
parts A, B and C are assembled as shown in
the diagram (32).
Screw it down again. Do not tighten too
hard, and do not use the capsule holder for
this purpose (33).
Descaling
To ensure that your appliance is working at its
best and for the best quality coffe, it is
strongly recommended that you regularly
descale your Krups Nespresso System (more or
less frequently, depending on the hardness of
your water, but at least once every six
months).
If you require further details, please contact
your Nespresso Club, which can provide you
with a complete descaling kit. The appliance is
delivered with a special hexagonal key and a
cleaning needle ; these tools can also be
useful when descaling your appliance.
Please note!
You should never, in any circumstance,
use vinegar !
Solutions to some problems
Problem:
The coffee temperature is too low .
Solution:
Refer to the section “Pre-heating Cups”
Preheat the empty capsule holder by running
through some hot water before making the
coffee.
Problem:
The pump is making a loud noise.
Solution:
Make sure there is water in the tank.
ART. 897.PM6.5 18/02/04, 10:1018
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Krups Nespresso 897 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Krups Nespresso 897 in the language / languages: English, German, Dutch, Danish, French, Italian, Spanish as an attachment in your email.

The manual is 0,89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info