480410
15
Zoom out
Zoom in
Previous page
1/50
Next page
15
Never immerse the appliance in water.
Keep out of reach of children and do not
allow the cord to hang down.
Follow the descaling instructions.
Do not use the appliance if it is damaged or
if the cord is in poor condition.
If the cord or any other specific part
becomes defective, these must be replaced
by a Krups approved service centre. You
should never, under any circumstances, open
the appliance yourself.
Check that the capsule holder is firmly in
place before making coffee.
Accessories
For best results, the appliance is delivered with
a set of accessories.
4 Nespresso cups
4 varieties of Nespresso coffee (4x10
capsules)
1 special hexagonal key (for dismantling the
capsule holder)
1 cleaning needle
For further information on the different
varieties of coffee available, or to order
capsules, you should contact your Nespresso
Club. Details on your appliance or in the «
Welcome Pack ».
Setting-up the appliance
Lift the water tank lid and remove the water
tank (1).
Fill the water tank with fresh water (2).
Maximum capacity is
1.8 l = about 25 espresso cups.
Replace the water tank and press down
firmly into position, so that the lower valve
opens (3).
Close the lid again.
For a good cup of espresso, it is
recommended tha you observe the following
points:
Empty the water tank after use.
Change the water every day.
Do not use mineral water or distilled water.
Clean the water tank at least once a week.
Before using your espresso
maker for the first time
Plug in the appliance.
Introduce the empty capsule holder into the
fixing ring : to do this, position the handle at
about 90° to the left, then thighten up by
pulling the handle firmly to the right (4).
§ Fill the water tank.
Place a container, large enough, under the
capsule holder and another under the steam
nozzle (5).
Turn the steam/hot water button to the
position
(6).
Press the ON/OFF key
, the red operating
indicator light will flash and all the green
indicator lights will come on (7).
Once the red operating indicator light stops
flashing the appliance is ready to be used (8).
By pressing the key
, the water will run
through the system (9).
Repeat this operation five times.
Press the
and turn the steam/hot water
button to the
position (10). Allow about
half a litre of water to run through and then
turn the steam/hot water button to the
position.
Preparation of Espresso
Fill the water tank (1) (2) (3).
Preheat the capsule holder, put it in position
on the machine, but without the capsule (4).
Turn the steam/hot water button to the
position
(6).
Press the ON/OFF key
, the red operating
light will flash and all the green indicator
lights will come on (7). Once the red
operating light stops flashing the machine is
ready for use (8).
ART. 897.PM6.5 18/02/04, 10:1015
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Krups Nespresso 897 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Krups Nespresso 897 in the language / languages: English, German, Dutch, Danish, French, Italian, Spanish as an attachment in your email.

The manual is 0,89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info