8
If the light comes
on, remove, empty and
clean the drip tray.
The drip tray receives waste water and the coffee grounds collector receives used coffee grounds.
The coffee cleaning tray allows you to eliminate any deposits of coffee grounds.
The light will remain on if the coffee grounds collector is not slotted in fully or not fitted correctly or if it has been
put back in less than 4 seconds. You cannot make espresso or coffee while the light is on or is flashing.
The coffee grounds collector has a maximum capacity of 14 coffees.
MAINTAINING YOUR APPLIANCE
As soon as you remove the coffee grounds collector, you will have to empty it completely to avoid any overflow.
MACHINE CLEANING PROGRAM – TOTAL DURATION: ABOUT 20 MINUTES
RINSING THE COFFEE CIRCUIT - SEE “BEFORE FIRST USE” SECTION
You should perform the cleaning program about every 350 preparations of espresso or coffee.
The appliance will let you know when you need to proceed with cleaning through the ‘clean’ light coming on.
Caution! To benefit from the warranty conditions, it is essential to perform the appliance cleaning cycle
when informed to do so. Be sure to follow the procedure closely, step by step.
You can continue to use the appliance when the light is on, but you are advised to perform the program as soon as possible.
EMPTYING THE COFFEE GROUNDS COLLECTOR, THE COFFEE TRAY
AND THE DRIP TRAY
Remove the coffee
cleaning tray.
Clean it under water
and
ddrryy tthhoorroouugghhllyy
.
Remove, empty and
clean the coffee
grounds collector.
The drip tray is equipped
with floats to tell you
when to empty it.
Press the ‘Service’
button to start up the
cleaning program.
The ‘clean’ and ‘coffee
ground collector’ lights
will flash.
Remove and clean the
cleaning tray then fit it
again.
Empty and clean the
coffee grounds collector
then fit it again.
The light will go off.
Place a receptacle with a
minimum capacity of 0.6 l
under the coffee outlets.
Remove, fill and re-fit
the water tank.
Remove and empty the
drip tray.
