565311
39
Zoom out
Zoom in
Previous page
1/242
Next page
41
EN
MALFUNCTION CORRECTIVE MEASURES
No steam is coming out of
the steam spout.
Empty the tank and temporarily remove the Claris cartridge.
Fill the tank with calcium rich mineral water (>100 mg/l) and per-
form successive steam cycles (5 to 10) into a container until you
obtain a constant flow of steam.
Re-insert the Claris cartridge into the tank.
The super cappuccino ac-
cessory does not make any
or makes little foam.
The super cappuccino ac-
cessory does not suck up
the milk.
Check that the accessory is correctly fitted to the appliance, re-
move it and then replace it.
Check that the flexible hose is not obstructed or pierced shaped
and that it is correctly connected to the accessory to avoid any
air entering.
Rinse and clean the accessory (refer to the "Super cappuccino
accessory" chapter).
If the problem persists replace the part surrounded in red on Fig.
20 with the replacement part supplied with your machine.
The machine is asking you
to empty the drip tray even
though it is not full.
The machine is programmed to ask for drainage of the drip tray
every 12 coffees, irrespective of any intermediate drainage that
you may carry out.
There is water under the ap-
pliance.
Before lifting off the tank, wait for 15 seconds after the coffee has run
through so that the machine finishes its cycle correctly.
Check that the drip tray is correctly positioned on the machine, it must
always be in place, even when your appliance is not being used.
Check that the drip tray is not full.
The drip tray must not be removed during a cycle.
When you turn off the ap-
pliance, warm water comes
out of the coffee nozzles.
According to the type of recipe prepared, the machine can carry
out an automatic rinsing operation when it is turned off. This cycle
lasts only a few seconds and stops automatically.
After emptying the coffee
grounds collector and clea-
ning the coffee drawer, the
warning message is still dis-
played.
Correctly refit the coffee drawer and the coffee grounds collector,
follow the instructions on the screen.
Wait at least for 8 seconds before refitting them.
The coffee comes out too
slowly.
Turn the grinding setting button to the right for coarser coffee
grounds (this can depend on the type of coffee used).
Perform one or several rinse cycles. Launch a clean programme
(see” Coffee circuit automatic cleaning programme" p.39).
Change the Claris Aqua Filter cartridge
(see "Filter installation"
p.33).
Water or steam are
abnormally coming out of
the steam spout.
At the start or end of the recipe some drops may fall from the
steam nozzle.
After filling the water tank,
the warning message
remains on the screen.
Check that the tank is correctly positioned in the appliance.
Check and unblock the float if necessary. The float at the bottom
of the tank should move freely.
IFU_KR_EA84_EO_NEW_EA84 28/05/13 17:10 Page41
39


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Krups EA8400 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Krups EA8400 in the language / languages: All languages as an attachment in your email.

The manual is 3,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Krups EA8400

Krups EA8400 User Manual - English - 28 pages

Krups EA8400 User Manual - German - 242 pages

Krups EA8400 User Manual - Dutch - 27 pages

Krups EA8400 User Manual - French - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info