590643
17
Zoom out
Zoom in
Previous page
1/43
Next page
2928
SETTINGS
All of the following options allow you to run the selected programs:
Measuring water hardness
It is advisable to adjust the appliance according to the hardness of the water used. To check the water hard-
ness, use the stick supplied with your machine or contact your local water authority.
Degree of
hardness
Classe 0
Very soft
Classe 1
Soft
Classe 2
Average hardness
Classe 3
Hard
Classe 4
Very hard
° dH < 3° > 4° > 7° > 14° > 21°
° e < 3,75° > 5° > 8,75° > 17,5° > 26,25°
° f < 5,4° > 7,2° > 12,6° > 25,2° > 37,8°
Appliance
settings
0 1 2 3 4
TURNING OFF YOUR APPLIANCE
You can turn off your appliance at any time. When stopped, the machine emits a double beep and OFF is dis-
played on the screen. The appliance has registered your request and will stop as soon as possible.
Installing the filter (Claris - Aqua Filter System cartridge) (32)
Note : To correctly install your cartridge, ensure that you follow the installation procedure each time you replace
it.
(33) A mechanism which memorises the month in which the cartridge was changed and replaced (after a maxi-
mum of 2 months): set the date using the cartridge cursor. Fit the cartridge in the tank (34). In the maintenance
and settings menu , the function indicator is located above the maintenance button .
Using the navigation button , select the filter cartridge installation symbol . The symbols and the
start button start to flash.
Place a 0.6 L container under the steam nozzle.
Press start . The start-up cycle begins and finished when the coffee types menu appears
SETTINGS
You can set your water hardness between 0 and 4.
See “Measuring water hardness” (below) by pressing the + or
– buttons
You can program automatic rinsing each time the appliance is
turned on by pressing the buttons and selecting ON.
You can choose the period after which your appliance will turn
off automatically (between 15 and 120 minutes by pressing the
buttons).
You can adjust the temperature of your coffee to three different
levels by pressing the buttons.
Return to coffee types menu.
If one of the problems described in the table persists, contact KRUPS customer service.
TROUBLESHOOTING
PROBLEM MALFUNCTION CORRECTIVE ACTION
Your machine detects a fault: a
symbol appears.
Switch off and disconnect the machine, remove the filter cartridge, wait for a minute
and restart the machine.
The appliance does not turn on
when the button is pressed.
Check your fuses and plug sockets.
Check that the two power plugs are pushed in properly both on the appliance and at
the socket.
The coffee grinder makes a
strange noise.
There is a foreign body in the grinder. Disconnect the machine before investigating.
See if you can extract the foreign body using your vacuum cleaner.
The steam nozzle makes a noise. Check that the steam nozzle is correctly attached to its corresponding end piece.
The steam nozzle on your
machine seems partially or
completely clogged.
Ensure that the opening in the end piece is not obstructed by milk residue or
limescale. Unclog the holes with the needle supplied with your appliance.
The steam nozzle makes little or
no milk froth.
For milk-based drinks, you use very fresh, very cold pasteurised or UHT milk. It is
also advisable to use a cold container. If the results do not improve, try changing
the brand of milk.
No steam comes out of the
nozzle.
Empty the tank and temporarily remove the filter cartridge. Fill the water tank with
mineral water which is high in calcium (> 100 mg/l) and run successive steam
cycles.
The auto-cappuccino set makes
little or no froth.
The auto-cappuccino set does
not take in milk.
Check that the accessory is correctly attached to the appliance, remove it then
replace it.
Check that the flexible tube is not obstructed or pierced and that it is correctly
attached to the accessory so as to make it airtight. Rinse and clean the accessory
(refer to the “Auto-cappuccino accessory” chapter).
There is water underneath the ap-
pliance.
Before removing the water tank, wait for 15 seconds after the coffee has finished
flowing so that the machine finishes its cycle properly.
Check that the drip tray is correctly positioned on the machine; it should always be
in place, even when the appliance is not in use.
Check that the drip tray is not full.
The drip tray should not be removed during a cycle.
After emptying the coffee
grounds collector and cleaning
the coffee drawer, the warning
message is still displayed.
Correctly replace the coffee drawer and the coffee grounds collector, follow the
instructions on the screen.
Wait at least for 8 seconds before replacing them.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Krups EA8150 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Krups EA8150 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 2,33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Krups EA8150

Krups EA8150 User Manual - English, German, Dutch, French, Italian, Portuguese, Spanish - 144 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info