KRUPS SERIE EA69xx
11
Press the ‘Service’ button
to start up the cleaning
program. The ‘clean’ and
‘coffee ground collector’ lights
will flash.
First put the cleaning tray
back then the coffee
grounds collector.
Light goes off.
Rinsing the coffee circuit - see page 7
10.2 Machine cleaning program - total duration: about 20 minutes
n You should perform the cleaning program about every 350 preparations of espresso or coffee.
n The appliance will let you know when you need to proceed with cleaning through the ‘clean’
light coming on.
Clean it under water and
dry thoroughly.
1- Remove, empty and clean
the coffee grounds collector.
2- Remove the cleaning tray
Caution! : To benefit from the guarantee conditions, it is essential to perform the appliance cleaning
cycle when informed to do so. Be sure to follow the procedure closely, step by step.
You can continue to use the appliance when the light is on, but you are advised to perform
the program as soon as possible.
!
1 2
h
h
1 2
h
h
Press the ‘Service’
button to start up the
cleaning program.
Press the back of the
cup stand to remove it
and insert a cleaning
pellet (Krups XS3000)
in the cleaning pipe.
1 - Cleaning cycle
± 10 mn
The ‘clean’ light becomes steady.
The cleaning cycle will be run automatically.
The pump sucks up water intermittently. This operation lasts about 10 minutes
and the ‘clean’ light will flash again.
2 - First rinsing
± 5 mn
The ‘clean’ light will become steady again.
The program continues.
A first rinsing cycle will be run automatically. It allows the ap-
pliance to be rinsed and remaining detergent to be eliminated.
This first rinsing cycle lasts about 5 minutes
and once finished the ‘clean’ light will flash again.
Remove, fill and re-fit the
water tank.
Place a container with a
minimum capacity of
0.6 l under the coffee
outlets.
Remove and empty
the drip tray.
XS3000
Empty your waste water
container and put it back
under the coffee outlets.
Again press the ‘Service’
button to start the first
rinsing cycle.
