KRUPS SERIE EA69xx
13
Caution! : Make certain to protect your work surface during cleaning and scale removal cycles,
especially if they are made of marble, stone or wood.
!
Caution! : Only use Krups F054 scale removal product. You can obtain scale remover from Krups Ser-
vice Centres. The manufacturer may not be held responsible for damage to the appliance
through use of other products.
!
Press the ‘Service’ key to
start up the scale removal
program. The ‘calc’
and lights will flash.
Place a container with a
minimum water capacity
of 0.6 l under the coffee
outlets and under the
steam nozzle.
Remove and clean the
drip tray.
Empty the tank and fill it
with lukewarm water up
to the ‘calc’ marking.
Dissolve a sachet of
Krups scale remover
F054 (40 g).
F054
Replace the water tank.
The light will go off.
Once you have performed
all these operations, press
the ‘Service’ key.
1 - Scale removal cycle
± 10 mn
The ‘calc’ light will become steady.
The scale removal cycle will have started and will be run
automatically. The pump will suck up water intermittently to
be expelled by the coffee nozzles and then the steam nozzle.
This operation lasts about 10 minutes. Once finished, the
‘water tank’ and ‘calc’ lights will flash.
2 - First rinsing
± 6 mn
A first rinsing is needed to eliminate the remaining scale remover.
This cycle is run automatically. It lasts about 6 minutes.
Empty your container
full of waste water.
Empty the drip tray and
then put it back again
together with the
container as previously.
Empty, clean and rinse the
water tank and then fill it
again up to the “Max.
level.
Replace your water tank.
The ‘calc’ light will flash
and the light will go
off.
Press the ‘Service’ key.
The ‘calc’ light will
become steady. The
automatic cycle will last
6 minutes.
3 - Second rinsing
± 6 mn
At the end of the first rinsing, the ‘calc’ light will flash. A second automatic cycle will last 6 minutes.
