705171

KRK Systems Rokit Powered G2 Series Manual

15
Zoom out
Zoom in
Previous page
1/20
Next page
14
The sound quality changes...
The monitor hisses, hums or makes other loud noises...
•
Repeat the steps in the Troubleshooting section above before continuing to the next
steps.
• Disconnect the signal cable at the input of the monitor. With power on, place your ear
close to each driver (tweeter/woofer) and listen for noise (i.e. a slight hiss or hum).
If there’s absolutely no sound whatsoever, it could be that one or more of the drivers
(woofer, tweeter or both) is at fault. It’s also possible that the problem lies somewhere
in the electronics.
• Play some non-distorted source material at a low volume. Carefully cover the tweeter
(to block the sound) without touching the diaphragm. Is the woofer producing a clean
sound? If there is not a clear tonal quality, or any sound at all, then the woofer
probably needs to be replaced.
• Cover the woofer so you can hear mostly the tweeter. Is the tweeter producing a clear
sound? If there is not a clear tonal quality, or any sound at all, then the tweeter
probably needs to be replaced.
• Once you have a better idea of what may be at fault please call our customer service de
partment. We will help you determine the best solution to correct your monitors. KRK
Customer Service can be reached at 1-800-444-2766, or by email at Service@Gibson.com.
Here are some suggestions that will help you eliminate these undesirables from your
system:
• Make sure that the power cord is plugged snugly into the IEC socket on the rear
of the monitor.
• Check the connections between the signal source and the monitor. The RoKit G2’s XLR
and TRS connectors are a completely balanced system. If you’re connecting an unbal
anced output to the monitor, be sure that you’re using Pin 2 for signal and have Pin 1
and Pin 3 tied together at the source end.
• Refer to the Connecting Your System section on page 6 of this manual to ensure
that the AC mains is matched to the operating voltage requirements.
• All audio equipment should use the same ground point. Check all other devices
using the same AC output in the building such as dimmers, neon signs, TV screens, and
computer monitors. These devices should not be using the same circuit.
rokit_manual REV E_rokit_manual 2/19/13 10:24 AM Page 15
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for KRK Systems Rokit Powered G2 Series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of KRK Systems Rokit Powered G2 Series in the language / languages: English as an attachment in your email.

The manual is 2,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info