819057

Kress KC720.9 Manual

12
Zoom out
Zoom in
Previous page
1/332
Next page
12
EN
3) For the best performance, keep the mower
housing free of built-up grass. From time to time
turn off mower and wait for the blades to come
to a complete stop. Remove the batteries and
turn mower on its side. Using an object such as a
stick, wipe out any accumulation of grass around
the blade area. Be careful of the sharp edges of
the blade. Ensure to clean the blade area often
when cutting wet or new grass and every time
after the machine is used.
4) Certain types of grass or grass conditions may
require that an area be mulched a second time
to fully disperse the grass throughout the lawn.
If cutting a second time, it is advisable to cut
perpendicular (across) the rst cut pattern. DO
NOT CHANGE CUT PATTERN IN ANY WAY THAT
WOULD CAUSE MOWING DOWN A HILL.
5) Change your cutting pattern from week to week.
This will help prevent matting and graining of the
lawn.
6) Do not mow on a slope that has an angle of
greater than 18
o
.
CUTTING AREA
The cutting area can be affected by several factors,
such as cutting height, lawn humidity, grass length
and density. Besides, starting and stopping the
mower too many times during operation will reduce
the cutting area.
TIPS:
1) It is recommended to mow your lawn more
frequently, walk at normal pace, and not to start/
stop the mower too often during operation.
2) For best performance, please ensure battery pack
is fully charged and always cut off 1/3 or less of
the grass height. It is suggested to install a new
blade before the cutting season begins.
3) Walk slowly when cutting long grass, so as to
have more effective cutting and properly discharge
the clippings.
4) Avoid cutting wet grass, otherwise it will stick
to the underside of the deck and the clippings
cannot be collected or discharged properly.
5) A higher cutting height shall be applied to new or
thick grass and it will extend the battery duration.
Removing/emptying grass collection bag
(See Fig. K1, K2)
WARNING! Always check the safety ap has
closed the discharge outlet before using. Never
lift the safety ap or remove the mulching plug when
the lawn mower is being used without tted grass
collection bag.
K1
K2
FOR BATTERY TOOLS
The recommended ambient temperature range for
discharging is -20 °C~45 °C (-4 °F~113 °F).
The recommended ambient temperature range for
the charging system during charging is -5 °C~45 °C
(23 °F~113 °F).
Details regarding safe disposal of used batteries:
At the end of the life of the appliance, remove the
battery pack safely before disposing of the appliance.
Do not throw batteries away or throw them in the
normal trash can. Also do not dispose of the battery
with the machine. Remove the used battery pack
from the appliance and dispose of it at the nearest
or convenient dedicated recycling facility. If in
doubt, consult your local environmental protection
department. Batteries may enter water cycle if
disposed improperly, which can be hazardous for
ecosystem. Do not dispose of waste batteries as
unsorted municipal waste.
TRANSPORTATION
Transporting the mower
1. Switch off the mower and remove the battery.
2. When transporting your mower, the self drive can
be used without enaging the cutting blade.
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kress KC720.9 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kress KC720.9 in the language / languages: All languages as an attachment in your email.

The manual is 103.63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info