508723
8
Zoom out
Zoom in
Previous page
1/31
Next page
SPEED DOME CAMERA 

INSTALLATION GUIDE
WALLMOUNT
Check carefully to make sure the wall is firm and does not peel off. It is required that the wall can withstand 8
times weight of the dome set.
1. Mark mounting position
Use bracket to mark the mounting position on
wall
2. Install bracket.
Conduct all cables through the hole of bracket, and
fix bracket on the wal
l
3. Release the connection board
Unscrew to release the circuit board on
connection board
4. 4. Install housing
Conduct cables through the hole on top of the
housing. Align the fast connector to bracket and fix
with 2 M5 screws.
NOTE: Apply water-proof tape to the thread in the
case of outdoor dome.
5 Connect cables.
Plug cables into corresponding sockets on circuit
board. Reinstall the circuit board and turn on the
power. The red LED is on if connections are
correct. Turn off the power after checking.
NOTE: Names of the interfaces are marked on
terminal block or PCB. Connect cables as picture
shows. Make sure power is off before connecting.
6. Set dome ID, baud rate and protocol.
Set dome ID, bard rate and protocol by configuring
DIP switches (see APPENDIX I ). Remove the
packing sponges.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Konig Electronic SEC-CAM901 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Konig Electronic SEC-CAM901 in the language / languages: English as an attachment in your email.

The manual is 2,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info