508771

Konig Electronic SEC-ALARM200 Manual

4
Zoom out
Zoom in
Previous page
1/76
Next page
4
To disable the alert zone feature:
1. Press [PROG] + MPIN [factory default 1 2 3 4].
2. Press [8] to select Alert Zone.
3. Press [3] to disable for zone 3. The zone 3 LED will flash after selected.
4. Press [PROG] when finished.
Notes: 1) The Motion Sensor is factory default in zone 3.
2) If the Motion Sensor doesn’t respond to your movement, try not to move in
front of the sensor for 20 seconds (i.e. no motion is detected in 20 seconds),
then walk again. The Motion Sensor is designed to be triggered only if no
motion is detected for 20 seconds.
Program Emergency Phone Number
During an emergency, the Control Panel can call up to 5 phone numbers to inform you
about an emergency situation. There are 5 phone memories, it will first call phone memory
1, then phone memory 2, etc. It will call phone memory 5 last. Each phone number can
have a redial count up to 9 times, and the emergency voice message can be repeated up
to 9 times. To program phone numbers, follow the procedures below.
Function Key Description Note
Enter program mode by MPIN [PROG] [MPIN]
Select program phone numbers [1]
Select phone memory [1] to [5]
Enter the phone number, then [Arm] [Phone Number] [Arm] Phone number
Enter redial count, then [Arm] [1] to [9] [Arm]
Enter message repeat count, then [Arm] [1] to [9] [Arm]
Note: Do not program police, or fire station phone numbers into any of the phone
memories.
Operation - Alarm
Arm
You should arm the Control Panel if you are the last person
to leave the house. To arm, press [Arm], Control Panel will
beep for 45 seconds, this is called the exit delay. You must
leave the house within 45 seconds.
Note: Control Panel can only be armed when no sensor is
triggered. Triggered sensors must be deactivated in
order to successfully arm the system.
… 4 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Konig Electronic SEC-ALARM200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Konig Electronic SEC-ALARM200 in the language / languages: English, German, Dutch, French, Italian, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 5,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info