508771
3
Zoom out
Zoom in
Previous page
1/76
Next page
3
Installation of
Sensors - Batteries
Insert batteries in all the sensors
and mount them accordingly.
Please refer to the User’s
Instructions for details on how
to install the Motion Sensor and
Door / Window Sensor.
Operation - Alert Mode
All the sensors are preprogrammed at the factory,
so the Control Panel can communicate with these
sensors after the batteries are installed properly.
Door/Window Sensor
Activate the Door / Window Sensor, you will hear
continuous beeping, one beep at a time, indicating
zone 1 sensor is activated. Activate the other
Door / Window Sensor, you will hear continuous
beeping, two beeps at a time, indicating zone 2
sensor is activated.
Notes: The door/Window Sensor is factory default
in zone 1 and zone 2.
Motion Sensor
To perform the walk test, its necessary to enable the Alert Zone (Bypass Zone) feature in
the Control Panel. After the walk test, it needs to disable this alert zone feature otherwise
it will bypass the signal in the alarm mode.
To enable the alert zone feature:
1. Press [PROG] + MPIN [factory default 1 2 3 4].
2. Press [8] to select Alert Zone.
3. Press [8] to enable for zone 3. The zone 3 LED will stay ON after
selected.
4. Press [PROG] when finished.
Walk in front of the Motion Sensor, you will hear the continuous beeping from the Control
Panel. Beeping will continue for approx. 20 seconds for every motion detected.
Remove the yellow
protective tag from
the sensors.
Insert 9V
alkaline battery
in the sensor
Beep
Activate the sensor
by opening the door,
you will hear voice
announcement and
continuous beeping.
Close the door, and
beeping stop.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Konig Electronic SEC-ALARM200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Konig Electronic SEC-ALARM200 in the language / languages: English, German, Dutch, French, Italian, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 5,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info