625968
200
Zoom out
Zoom in
Previous page
1/226
Next page
MAINTENANCE PROCEDURES
198
7. Loosen the screws (1), remove the plate (2) and slowly
loosen the filler cap (F) to release the residual pressure from
the tank.
8. Remove the drain plug (2) and let the oil flow out, gathering it
into a container with suitable capacity.
9. Loosen the clamps (3), remove the suction pipe (4) and let
the oil that is still in the tank flow out.
10. Remove the screws (5), remove the flange (6) and clean the
air intake filter (7).
IMPORTANT
q Carefully check the filtering element grid and if it is not in
perfect conditions, change it.
11. Put back the drain plug (P), the lower flange (6) with the filter
(7), checking the soundness of the gasket, and the suction
pipe (4) with the clamps (3).
12. Fill with prescribed oil until reaching the level (G).
Use only oil of the prescribed type (see «4.4 FUEL,
COOLANT AND LUBRICANTS »).
13. Close the cab floor.
14. Extend the boom, arm and bucket cylinders completely, as
shown in the figure, and remove the filler cap (F).
Put back the cap and pressurize the tank by lowering the
equipment to the ground.
15. Make sure that all the control levers are in neutral position
and let the engine idle for at least 2÷3 minutes before
operating the work equipment.
Move each piston more than once to deaerate the system;
check and top up if necessary.
CAUTION
q Do not start the engine with empty tank, since this would
certainly damage the pump.
200


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Komatsu Galeo PC14R-2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Komatsu Galeo PC14R-2 in the language / languages: English as an attachment in your email.

The manual is 6,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info