625968
134
Zoom out
Zoom in
Previous page
1/226
Next page
TRANSPORTING THE MACHINE
132
3.4 TRANSPORTING THE MACHINE
When transporting the machine, observe all the laws and regulations in force, paying special attention to safety.
3.4.1 TRANSPORT PROCEDURE
As a general rule, the machine must be transported on a trailer.
Choose the trailer according to the weight and size of the machine, as indicated in paragraph "5.1 TECHNICAL
DATA"It is important to remember that the weight and transport size indicated in the technical data may vary
according to the type of track, to the type of boom or to the other attachments installed on the machine.
3.4.2 LOADING AND UNLOADING THE
MACHINE
WARNING
q During loading and unloading operations, make sure that
the travel speed increase warning light (1) is off and always
travel at low speed.
q During loading and unloading operations, let the engine
idle, reduce speed and operate the machine slowly.
q The machine must be loaded and unloaded on/from the
trailer on firm and level ground. Keep a safety distance
from the edge of the road.
q Use sufficiently wide, long, thick and strong ramps, and
position them with a maximum inclination of 15°C. When
using piled soil, compact it to prevent the inclined surface
from collapsing.
q Before loading the machine, remove any trace of mud and
dirt from the tracks, in such a way as to prevent the
machine from slipping when it is on the ramps. Make sure
that the surface of the ramps is clean and that there are no
traces of water, snow, ice, grease or oil.
q Do not change direction when the machine is already on
the ramps, since it may overturn. If necessary, move the
machine down the ramps, find the correct direction and go
up again.
q It is dangerous to use the work equipment for the loading
and unloading operations, therefore avoid this type of
manoeuvre.
q When the machine is on the ramps do not operate any lever
apart from the travel levers.
q When the machine goes up the ramps and when it passes
from the ramps to the trailer, its centre of gravity changes
suddenly and it may lose stability. Therefore, proceed
slowly.
q If the turret swing is operated when the machine is on the
trailer, this becomes unstable, therefore it is advisable to
fold the work equipment and to swing the turret slowly.
q Widen the track gauge before the loading and unloading
operations.
134


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Komatsu Galeo PC14R-2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Komatsu Galeo PC14R-2 in the language / languages: English as an attachment in your email.

The manual is 6,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info