23
1) Bring your pool vacuum to the side of your pool / spa. Immerse the pool vacuum in
water and press the power button to initiate operation.
CAUTION! Make sure the pool vacuum is always facing downwards when it is placed into
the pool. Otherwise it may bend the pole connector and damage it during the process.
2) To remove the pool vacuum from the pool / spa, lift the pool vacuum while pointing it
downwards in order to allow water to escape from the outlet valve. Water is going to
escape via the handle / pole connector and draining holes inside the handle chamber
on the rear body.
CAUTION! Make sure the pool vacuum is always facing downwards when it is removed
from the pool. Otherwise, the pole connector may be bent and damage the pool vacuum
in the process.
2) Rinse the pool vacuum with fresh water after every use. DO NOT use any detergent.
EMPTYING THE FILTER
WARNING! Using the pool vacuum without a filter bag in place will VOID your
warranty.
In order to maximize the cleaning efficiency, be sure to clean the filter bag before and after
each use.
CAUTION! If the pool vacuum is charging, disconnect the external adaptor from the power
source and detach the pool vacuum from the charger base.
Emptying the filter bag
1. Place the pool vacuum on a stable surface.
2. Press the locking button until the locking hole on the clear canister is released. Slide the
canister away until the notch on the bottom of canister opening is released from the hook
on the bottom of main body. Remove the filter bag from the main body.
CAUTION! Replace the damaged filter bag immediately before the next operation.
3. Clean out the debris and rinse the filter bag with water. If brushing is deemed necessary,
use only a soft brush to clean the bag gently and carefully.
4. Re-position the filter bag inside the main body. Make sure the net is completely inserted
inside the main body and does not stick out.
