Danger of scalding by splashing hot food!
Never use the Pulse button, high speed or abruptly increase the speed above speed 3 when
processing hot food.
Danger of injury by escaping food
Turn the Measuring cup to lock position while operating at higher (6 –10) speed levels or
pressing Pulse button to chop or to purée cold food to avoid the measuring cup or food
splashing out.
Property damage
Place your appliance on a clean, solid, even and non-heatable surface so that it cannot slip. Keep
the appliance in a sufficient distance from the edge of this surface to prevent it from falling
down. When preparing dough or chopping food, an imbalance can develop in the mixing bowl
which, under certain circumstances, may cause the whole appliance to move. Do not leave the
appliance unattended while it is operating as it might fall from the work surface.
When Kneading dough, never use a low speed of 1-4 at the beginning, always mix the dough at
higher speeds for a few seconds, then set the speed back to 2-3 for 3-4 minutes. Never use the
Mixing tool when Kneading dough. If the blades become jammed or the unit begins to seriously
vibrate, turn it off immediately to avoid damaging the appliance.
Pulse and High Speeds (7-10) are only designed for short time operation, never use this function
for more than 30 seconds at one time.
Leaking of food
Ensure the sealing ring of the blade is fitted to the blade bearing.
If there is no sealing ring the food to be mixed or cooked may leak out and
damage the appliance.
Cleaning
•Before using the ThermoBlend 2 for the first time and after each use, clean the machine,
its components and accessories thoroughly.
•The contact points that are at the bottom of the bowl should always be clean and dry.
•Special care must be taken when removing the chopping blade from the bowl as they are
very sharp.
•All the stainless steel components of this machine can be washed in the dishwasher,
however it is recommended that you wash the plastic components by hand.
Note: Remove the seal prior to washing blade assembly and ensure both parts are dried before
fitting back together.
•Clean the sealing ring that can be found in the cover after each use.
•Thoroughly dry all the components and bowl accessories after each wash for optimum
performance of the machine.
•Clean the cavity of the central unit with a damp towel, then dry well.
Warnings
•Never immerse the main unit, cord and plug into any liquids.
•Do not using the Mixing Tool for kneading.
•Do not use speeds 1-3 at the beginning of the kneading process.
•Do not mix frozen fruit or frozen meat.
•Cease use immediately if excessive vibrations are experienced during use;
serious damage to the machine can occur if these warnings are not followed.
11
