782830

Koenic KFZ 521 E NF Manual

23
Zoom out
Zoom in
Previous page
1/26
Next page
23
18
Connect the plug and the socket. Clip the
supplied cap onto the hinge, make sure not
to damage the cable.
19
Pull the two caps o the rails of the door
handle.
20
Remove both cross-head screws.
21
Rotate the handle and place it into position
after removing the blind caps on the other
side of the door.
22
Fasten the handle.
23
Place the two caps on the rails of the door
handle. Insert the blind caps into the holes
that are now visible in the previous position
of the handle.
Caution
After you have placed the freezer upright
on its feet, wait for 24 hours before you
connect it to the mains to permit the cooling
system to regain full capacity.
Energy saving tips
• Do not place the product in the vicinity of a
heat source (radiator or kitchen stove, etc.).
• Ensure unobstructed air flow around the
refrigerator and freezer.
• If a layer of ice has built, defrost the unit. A
thick layer of ice aects the transmission of
the cold, thus the energy consumption will
be increased.
• When opening and taking out food, only
open the door shortly. A shorter door
opening time causes less ice to deposit on
the freezer walls.
• Select the temperature regulator setting
according to the filling amount of the
product.
• Use drawers, baskets or shelves to store the
food. If the energy of the product is used
eciently, the energy consumption can be
minimized.
• It’s advised not to remove the provided
accessories, such as drawers, shelves
balconies, as this might increase the energy
consumption, due to inecient storage of
food.
Cleaning and care
Warning
• Unplug the product before cleaning.
• When cleaning, never use solvents or
abrasive materials, hard brushes, metallic
or sharp objects. Solvents are harmful to
human health and can attack plastic parts,
while abrasive cleaning materials and tools
may scratch the surface(s).
• Never use oil or grease on the door seal.
This will make it porous over time.
• Do not use steam cleaning equipment. The
steam may come in contact with electrical
parts of the product, causing a short
circuit.
Note:
The appliance should be cleaned every four
weeks for good maintenance and to avoid
contamination of food.
Use a soft cloth or sponge for cleaning.
• Clean the product’s exterior surfaces with
a slightly damp cloth and then dry them
thoroughly.
• Make sure that no water enters the product
interior (for example, through the display).
• Wipe the door seal with clean water only, and
dry it thoroughly afterwards.
Cleaning the interior
• Removable parts e.g. glass shelves, can be
taken out for cleaning.
• Remove trays, freezer compartments and
the pizza tray from the inside and clean them
with detergent in lukewarm water. Rinse the
parts with clean water and dry them.
• After removing all trays and compartments
and defrosting the freezer, wipe the interior
with a vinegar solution. Dry the interior
thoroughly.
… 23 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Koenic KFZ 521 E NF at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Koenic KFZ 521 E NF in the language / languages: English, German as an attachment in your email.

The manual is 2.22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info