Manual Koenic KFZ 521 E NF (page 22 of 26) (English, German)

782830

Zoom out

Zoom in

1/26

Note: The alarm function is activated

at any moment and will indicate a rapid

increase of the internal temperature. In

addition an acoustical signal will sound.

Child lock - Key lock: If this

function is activated, no settings can

be changed. However, the key lock can

be disabled in the same way as it is

activated.

Fig. 7To switch the freezer on and o, press

and hold the ON/ OFF switch OK/

5S for at least 5 seconds. This allows

the freezer to be switched on and o

without using the mains plug.

Fig. 8If you need ice cubes ﬁll the ice cube

tray with water. Place the ice cube

maker in the freezer and wait several

hours. If the liquid is suciently frozen,

turn the knobs (a, b) to the right and

then release them. The ice cubes fall

into the tray. If necessary shake the

ice cube maker together with the

collecting tray.

Adjust the side of the hinges

Attention

Make sure that the freezer stands safely

during work and cannot tilt.

Note:

• If necessary, and if the premises require it,

the mounting of the doors can be changed.

To do this, follow below instructions in the

given order.

• The following tools are required:

Socket wrench 8 mm, wrench 8mm, phillips

screwdriver, slotted screwdriver. Due to

the uniqueness of the appropriate tools,

those are not mentioned separately in the

following instructions.

• For this work a dierent hinge holder and

cover are needed, which are provided with

the unit.

Caution

• Pull out the mains plug!

• The mounting should be performed by at

least 2 persons to avoid dangers.

1 Pull o the top cover. If necessary use a

plastic card or spatula to loosen the cap.

2 Disconnect the plug and socket.

3 During unscrewing hold the refrigerator door

or it might be damaged. Remove the three

screws of the top hinge.

4 Pull out the door and place it on a soft and

clean surface.

5 Remove the blind cap on the top of the

freezer (use a plastic card or spatula to help

loosen the cap) and insert it into the holes

on the right side.

6 Pull o the front panel and place the cable

as shown.

7 Make sure the LED light bar is seated in the

guides and attach the front panel back to

the front.

8 Loosen the two caps on the top of the door.

9 Insert the end of the cable into the hole and

close it with the blind cap.

Pull the other cable out and close the hole

with the cap having the cable gland.

Loosen the angled plate on the bottom of

the door and screw it on the other side. Do

not turn the metal plate and note that the

small holes must be placed on the plastic

pins while the screw hole and the tapped

hole must be aligned.

Loosen the three screws on the lower

hinge plate and remove it. If necessary tilt

the refrigerator to get better access to the

bottom side.

Unscrew the hinge pin and screw it back on

the other side.

Place the hinge plate on the left side into

position.

Tighten the hinge plate securely.

Place the door on the lower hinge pin.

Keep the door in position. Take the additional

hinge provided and insert the hinge pin into

the corresponding hole in the door. Hold the

hinge plate in position and screw it.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Koenic KFZ 521 E NF in the language / languages: English, German as an attachment in your email.

The manual is 2.22 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Koenic KFZ 521 E NF Manual

Product: