753679
20
Zoom out
Zoom in
Previous page
1/64
Next page
20
EN
INSTALLATION
Unpack the appliance, then check and make sure that all the accessories including
ice basket and ice scoop etc. are complete. Please contact customer service if some
accessories are missed.
Please follow the operation as below to install the handle well in position.
1. Grasp both sides of the handle shown in arrows with hands and pull them
outwards (see gure 1).
2. Make the handle align with the holes at the housing and release the hands,
then the handle is inserted into the holes of housing (see gure 2).
3. Pull and make the handle be upright, then pull both sides of the handle
outwards by following the operation of step 1. Check and make sure that the
handle shall be positioned well at the holes of housing.
4. Grasp the center of handle and lift it upwards (see gure 3), check and make
sure that there shall be no abnormal condition can be found.
Figure 1 Figure 2 Figure 3
Ensure the appliance is level and on a stable table or platform to avoid malfunction.
The incline angle of the ice cube maker cabinet should not exceed 45°during
transportation or use. Do not turn the appliance upside down. Doing so could cause
the compressor or refrigerating system to operate incorrectly. Please allow time for
the uids in the compressor to settle after the appliance is moved or transported.
Before using the ice cube maker for the rst time, please wait for 2 hours after the
unit has been levelled and positioned in the proper place.
The appliance must be placed on a dry and level surface with sufcient ventilation,
far from heat sources such as ovens, heaters and corrosive gases. Leave about a
15cm clearance on all sides of the appliance for proper ventilation.
Do not ll the water reservoir with hot water. This may damage the ice cube maker.
It is best to ll the water reservoir with water of room temperature or lower.
Do not use the appliance at a very cold environment (lower than 5°C).
Clean the appliance before use (see section „Cleaning and Maintenance“).
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Klarstein 10035553 Arctic-Porter at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Klarstein 10035553 Arctic-Porter in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 0,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info