768512

Kiwy Alia Manual

9
Zoom out
Zoom in
Previous page
1/58
Next page
seat, and pulling frontward the shoulders' straps, seizing them from be-
low the chest protection pads (Fig. 17).
NOTE: These pads, as well as the crotch strap, have a xed length that
cannot be adjusted.
Place the child in its seat and fasten the seat straps, combining the two
tabs (Fig.19), and inserting them into the buckle until you hear a 'click',
conrming it's fastened.
With refence to Figure 20, place the harness straps on the shoulders, and
the crotch strap and the buckle between the child's legs.
Pulling the front adjustment strap (2), tension the straps so that they are
adhering to the child's body (1). Finally, pull down the chest pads.
NOTE: Too much tension can be disruptive for children, with the conse-
quent risk that they try to get rid of it. For this reason, the straps adjust-
ment is meant to just eliminate any excess.
Using the adjusting lever ( Part M of Fig.2 ) you can change the inclina-
tion angle of the seat (Fig.7 ).
To remove the child seat
To remove the child seat from the car seat, push the release buttons on
both of the Isox connectors to release them from their anchoring po-
ints ( Fig.21 ).
Unhook the Top Tether and store it in it's proper place in the back of the
backrest.
This is a SEMI-UNIVERSAL Child Restraint System , approved to European
Standard ECE R 44 04, for general use in vehicles, and it may be installed
on most, but not all, vehicles (see Vehicle Application List).
If in doubt, please contact your retailer or, directly, the manufacturer.
In this weight group, the child is restrained directly by the car safety belt,
so you don't need to use the child seat ve-point harness, while the child
car seat is xed to the vehicle seat by the Isox connectors.
To set the seat to this condition, proceed as follows (Fig.22):
Lift completely the headrest (Part I of g.2).·
Release both straps from the crotch buckle (Part J of g.2). ·
Installation method for children from 15 to 36 kg (Group 2,3)
· Make sure that the vehicle seat headrest doesn't affect the correct po-
sitioning of the child car seat, and removing it if necessary (Fig. 9 ).
Fixing to the ISOFIX vehicle anchorage points
Referring to Fig. 10, press the Isox extension buttons (1) on both sides
of the child seat to extract the Isox connectors (2).
Make sure that the signal close to the button is red, to indicate that each
connector is ready to be hooked.
NOTE: In some cars it can be difficult to insert the connectors in its pro-
per anchor point; this child seat comes with two Isox plastic guides
(Part.Q of Fig. 3) that can be xed in advance on the Isox anchoring po-
ints in order to semplify the insertion of Isox connectors.
IMPORTANT: When the Isox connectors are properly hooked to the an-
chor points, the red signals become green, and you hear two distinct
'clicks' to conrm the correct fastening of both of the connectors.
Push strongly the child car seat against the vehicle seat backrest (Fig.13)
until they are in close contact.
Use of the Top Tether strap
Open the Top Tether storage lid (Part W of Fig.3) and extract the Top Te-
ther strap.
Press the adjuster (Part.V of Fig. 3) to lengthen the strap by pulling the
Top Tether by the snap hook (Fig.14).
Hook the snap hook (Part. U of Fig. 3) into the Top Tether anchoring po-
int recommended in your vehicle owner's guide (Fig. 15).
To Tension the Top Tether, remove the slack by pulling the free end of
the strap from its adjuster (Fig. 15a) .
T he Top Tether is correctly tensioned when the green tension indicator
is fully visible through the adjuster window.
WARNING :
Always check that the Top Tether has no slack and it's not twisted.
Use of the 5- point Harness:
Press down the red button (Fig.16) to open the harness buckle.
Loosen the harness straps as much as possible by pressing the harness
release button (Part. L of Fig.2 ), located in the front middle of the child
8 9
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kiwy Alia at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kiwy Alia in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 5,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info