Disconnect the appliance from the mains power supply before
starting operations.
• The ice maker and water circuit must be connected to a water
supply of drinkable and/or chemically purified water.
• The water connection must be carried out in compliance with
local water regulations.
• The appliance is supplied with a water tube and with a transition
connector for connecting to the water tube to the supply.
(selected models)
• Remove the protective cap from the end of the gray water tubing.
• Connect the water tube (1) to the transition connector (2).
Tighten to finger tightness and then tighten 1 or 2 additional turns
only (for some models connector is placed directly on water
tube).
• Connect the transition connector (2) to the household water
supply (3).
• (4) Remove Plastic cap from water valve inlet port.
• (5) Place end of Plastic tubing into water valve inlet port.
• (6) Slide brass nut over sleeve and screw the nut into the inlet
port. Tighten the nut with a spanner taking care not to over
tighten. Connect tubing to frame with water tubing clamp (C).
• Ensure that the water tube is not twisted.
• The appliance is pre-set for operation at pressures between 0.24
and 8.3 bar MPascal (2.4 and 8.3 bar / 35 and 120 PSI).
• Open the water tap. Check for and eliminate any leaks.
• The appliance does not require any adjustment or water drain.
Water connection
25
