Leveling
• Do not use power tools when performing the leveling procedure.
• To enhance the appearance and maintain performance, the
refrigerator should be level. (side to side)
Note
Complete any required door reversal, panel installation and/or a water
supply connection, before leveling.
Materials Needed
• 3/8” hex head driver
• A Spirit level
1. Remove the toe grille.
• Grasp firmly and pull out carefully to unclip.
2. Remove the bottom bracket cover(s).
• Place the eraser end of a pencil or similar blunt tool in the cover
notch.
• Use a slight pressure to carefully pry the cover loose.
• Continue the downward pressure to the notched side of the cover
while swinging it off.
3. Using hex head driver, turn the front adjustment screws (A) on each
side to raise or lower the front of the refrigerator.
Note
• Some models only have adjustment screws “A”.
4. Selected models also have rear adjustment screws (B). Using the hex
head driver, turn each of these adjustment screws (B) to raise or
lower the rear of the refrigerator.
5. Using spirit level, make sure front of refrigerator is 6 mm or half
bubble higher than back of refrigerator and that the refrigerator is
level from side to side.
6. Turn stabilizing legs (C) clockwise until firmly against floor.
7. Freezer drawer models only: Turn adjustment screws (A)
anticlockwise to allow the full weight of the refrigerator to rest on the
stabilizing legs.
8. Replace the bracket cover(s).
• Position cover into the outer edge of the hinge.
• Swing the cover toward the cabinet and snap it into
place.
9. Replace the toe grille.
Note
• For proper reinstallation, ensure the “top” marking on
the interior of the toe grille is oriented correctly.
• Align the toe grille mounting clips with the lower cabinet slots.
• Snap bottom portion into place first. Press down firmly on the top of
the grille until top portion snaps into place.
Installation
23
