Before any cleaning or maintenance operation, unplug the appliance
from the mains or disconnect the electrical power supply.
Periodically clean the refrigerator and freezer compartments with a
cloth and a solution of lukewarm water and mild detergent.
Never use detergents or abrasives. Never clean refrigerator parts
with flammable fluids. The fumes can create a fire hazard or
explosion.
Clean the outside of the appliance and the door seal with a damp
cloth and dry with a soft cloth.
Do not steam clean.
Important: the buttons and control panel display must not be
cleaned with alcohol or alcohol-derived substances, but with a dry
cloth.
Always disconnect the refrigerator from the power supply
before replacing any light bulbs.
Replacing light bulbs
Refrigerator compartment
1. Slide clear light lens/shield towards the back of the compartment
to release from the light assembly.
2. Remove light bulbs.
3. Replace the light bulb with a similar bulb with a maximum power
of 40 watts. These are available from our Customer Care Centre
or from authorised dealers.
4. Replace the light lens/shield by aligning edge of shield with the
control housing. Slide the shield toward front of the refrigerator
until it locks into place on the ‘T’ shape locking tab. Do not force
the shield beyond it’s locking point. Doing so will damage the light
lens/shield.
Freezer compartment
1. Reach behind the light cover.
2. Using a firm pressure, press the notches on the back of the cover
forward and pull down. The cover will open from the back.
3. Remove the cover.
4. Remove the light bulb.
5. Replace the bulb using a similar light bulb with a maximum
power of 40 watts. These are available from our Customer Care
Centre or from authorised dealers.
6. Insert the front tabs of light cover into slots in the freezer liner
and snap the rear portion over light assembly until the rear tabs
engage.
Maintenance and cleaning
15
