611493
11
Zoom out
Zoom in
Previous page
1/20
Next page
11
After unpacking the product, check for any damage during transport.
In case of problems, contact the dealer or the After-Sales Service.
For built-in dimensions and installation instruction, see the pictures in page 5.
PREPARING THE CABINET FOR FITTING
- The lower part of the product must not be accessible after installation.
- Do not fit the separator panel if an undertop oven is installed.
These instructions are aimed at qualified fitters as a guide to installation, adjustment and maintenance in
compliance with the laws and standards in force. The operations must always be carried out with the
appliance disconnected from the electricity supply.
Positioning
The appliance is made to be fitted into a counter top, as show in the figure. Apply the sealant supplied
around the whole perimeter of the hob. Installation over an oven is not recommended, but if this is
necessary, check that:
- the oven has an efficient cooling system;
- there is no passage of hot air from the oven to the hob;
- allow air passages as shown in the figure.
To fasten the surface to the top, use the brackets with screws provided and the sealant, which is placed
under the perimeter edge of the surface and the top where it is installed.
If needing to install multiple Domino products in the same cut-out, the Domino Connector (not included)
accessory 481010793572 must be purchased separately from the After-sales Service.
In addition, also order special kit 480121103229 in case of installation in a stone counter top.
WARNING
Installation
- Disconnect the appliance from the power supply.
- Installation must be carried out by qualified personnel who know the current safety and
installation regulations.
- The manufacturer declines all liability for injury to persons or animals and for damage to
property resulting from failure to observe the regulations provided in this chapter.
- The power cable must be long enough to allow the hob to be removed from the worktop.
- Make sure the voltage specified on the dataplate located on the bottom of the appliance is the
same as that of the home.
WARNING
Electrical connection
Before first use
First cleaning
Remove the protective film.
Clean the control panel with a damp cloth.
Clean the cooled cooking surface with a damp cloth, wiping in the direction of the pattern.
WARNING! We recommend not using sharp tools or abrasives for cleaning. They could damage the surface
.
Description of the appliance
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for KitchenAid KHTD2 38510 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of KitchenAid KHTD2 38510 in the language / languages: English as an attachment in your email.

The manual is 0,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of KitchenAid KHTD2 38510

KitchenAid KHTD2 38510 User Manual - German - 20 pages

KitchenAid KHTD2 38510 User Manual - Dutch - 20 pages

KitchenAid KHTD2 38510 User Manual - French - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info