CLEANING THE SPRAY ARM
1. Remove the basket carefully. Lift from the back end first so that
you do not knock the detergent and rinse aid dispenser.
2. Lift the spray arm and shake any foreign material out.
3. Rinse the spray arm under water and wipe the spray arm with a
damp cloth.
4. Replace the spray arm back onto the impeller.
CLEANING THE DRAIN FILTER
1. Lift up the drain filter access panel, if fitted on the basket.
2. Lift and remove the drain filter out of the DishDrawer®.
3. Empty, rinse under clean running water and replace back into the
allocated space.
4. Ensure the drain filter is flush with the filter plate.
CLEANING THE FILTER PLATE
1. Ensure the DishDrawer® is cool before you start cleaning and
follow the instructions for removing the drain filter and spray arm.
2. In the centre of the filter plate, there are two rings. Hold the
centre ring still and turn the outer ring anti-clockwise, about a 1/8
turn. This will release the filter plate.
3. When cleaning the underside of the filter plate, care must be
taken on the sharp outer edge to avoid the risk of cut type
injuries.
4. Remove any soil, wash in hot soapy water and rinse thoroughly in
clean water. The heater plate can be wiped with a damp cloth.
5. Replace the filter plate so it lies flat in the base of the
DishDrawer® ensuring the filter plate is fully locked into position
with the centre ring.
6. To lock the filter plate into position, ensure the lines align with
each other (refer to the diagram for the correct position). The
filter plate must not be able to move about freely.
WARNING
The DishDrawer® must be used with the filter plate, drain
filter and spray arm correctly in place.
1
2
3
15
1. Impeller
2. Centre Ring
3. Outer Ring
