18
The appliance must be installed and tested in full compliance with the accident prevention laws and
regulations, of the traditional and current regulations.
ELECTRICAL CONNECTION
Before installing the blast chiller, make sure that the existing electrical systems are in compliance with the
law and suitable to the data of the rating plate of the appliances to be installed (V, kW, Hz and power
available). The appliance is supplied with a 2.50 m long power cord with a 16A Schuko plug.
Important! Make sure that the plug is accessible even after the successful installation!
In the event that the appliance plug is not easily accessible, the power supply must be equipped with all-pole
disconnect devices with an opening gap for the contacts that allows complete disconnection in conditions of
overvoltage of category III.
Important! If the entire length of the cable is not used, DO NOT roll it on itself but leave it free and make
sure it will not prevent the passage of people and cause danger; also make sure that it is not squashed or bent.
Important! Make sure that the power cord does not come into contact with liquids of any kind and sharp,
hot and corrosive substances.
Do not allow children or pets to play with the power cord.
POSITIONING
The blast chiller is a built-in appliance. Avoid positioning indoors at high temperatures and poor air
exchange, to direct sunlight or weathering, near heat sources. For proper air exchange, it is required to leave
the rear wall of the compartment open, making sure that the interspace for the passage of air is at least 45
mm. (fig. 11).
Installation
min. 45
min. 560
min. 575
min.
