483676

Kinzo 71775 Manual

6
Zoom out
Zoom in
Previous page
1/52
Next page
6
A
Technical daTa
Voltage: 18V DC
No-load speed: 0-550/min
Drill chuck capacity: 10 mm
Torque setting: 20+1 positions
Clockwise/ counter- clockwise rotation
Rechargeable battery: 18V
Battery capacity: 1000mAh, Ni-Cd
Charger rating input: 230V~50Hz
Charger rating output: 21V DC, 400mA
Charge time: 3-5 hours
oPeraTion inSTrucTionS
1. Charging the battery pack
The battery pack for this has been shipped in a low charge condition to prevent possible problem.
You should charge them prior to use.
Note: Batteries will not reach full charge the fi rst time
they are charged. Allow several cycles (drilling followed
by recharging) for the item to fully charge. The battery
should only be used indoors.
Place the battery pack into the charger as indicated.
The battery as supplied is not fully charged. Therefore,
let the tool charge initially for 7 hours. After the initial
Charge, under normal usage, your tool should be fully
charged in 3 to 5 hours. The battery pack will become
slightly warm to the touch while charging, this is nor-
mal and does not indicate a problem. Do not place the
charger in an area of extreme heat or cold,
it will best at normal room temperature.
Charging indication:
The charger has a red LED lights.
The red light is a power indicator, when the charger is plugged in,
the red one lights. Push the battery pack to make sure contacts on battery pack engage properly with con-
tacts in charger. When properly connected, the red light is still lighted that means the battery is charging.
When the battery is loaded, the green light is extinguished and the red light keeps illumining until the
charger is disconnected from mains power.
2. Removal / insertion of battery (Fig. 3)
1. Before making any adjustments ensure the drill is switched off
with the reversing
switch in the centre position.
2. Hold the drill with one hand and the battery pack (7) with the other.
3. To install, pull and slide battery pack into battery port, make sure the latches
(6) on each side snap into place and battery is secure before
begging operation.
4. To remove, use your thumb and fi ngers, press the battery release latches in
and pull the battery pack off at the same time.
3. Switch (Fig. 4)
The drill is started and stopped by depressing and
releasing the ON/OFF switch trigger (4).
This cordless drill is equipped with an electric brake,
when the on/off switch is released completely the
chuck stops immediately.
Fig. 4 Fig. 5
3
4
Fig. 3
Battery pack
Red light
Charger
Fig. 2
71775 Manual.indd 6 31-12-10 15:35
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kinzo 71775 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kinzo 71775 in the language / languages: English, German, Dutch, French, Polish as an attachment in your email.

The manual is 5,03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info