606693
52
Zoom out
Zoom in
Previous page
1/104
Next page
46
USB
AGC AUTO MONI
USB
AGC AUTO PROC
8 Press [METER] to select the COMP function to allow
you to monitor the compression while transmitting.
9 To switch OFF the processor, press [PROC] again.
•“PROC goes out.
Note:
Input audio that is controlled by the AGC will be clipped.
Therefore, when mixing audio with the operators voice, lower the
MIC
gain control as necessary.
CHANGING FREQUENCY WHILE TRANSMITTING
Moving your frequency while transmitting is usually an
unwise practice due to the risk of interference to other
stations. While transmitting, if you select a frequency
outside the transmit frequency range, the transceiver is
automatically forced to receive mode. If transmit was
selected using the [SEND] key, transmission will not be
resumed until you select a frequency inside the transmit
frequency range, and you transmit again.
TRANSMIT MONITOR
The Transmit Monitor function allows you to hear your
own transmitted signal.
Press [MONI] to toggle the Monitor function ON or OFF.
To change the volume of the monitored audio,
adjust the MONI control.
7 OPERATING AIDS
SPEECH PROCESSOR (SSB/AM)
The speech processor functions by leveling the large
fluctuations in your voice when you speak. This leveling
action effectively raises the average transmit output
power resulting in a more understandable signal when
operating using SSB or AM. You will notice that using
the speech processor makes it easier to be heard by
distant stations.
1 Select SSB or AM mode.
2 Select the preferred processor characteristics via
Menu No. 25 (PROC.LOW) and Menu No. 26
(PROC.HI).
You can customize the low and high ranges of
the speech envelope from 6 to +6 dB.
3 Press [PROC] to switch ON the processor.
•“PROC lights.
4 Press [METER] to select the COMP function.
5 While speaking at your normal voice level, adjust the
PROC control for a level of 10 dB or less.
Using higher compression will not improve your
signal clarity or apparent signal strength.
Excessively compressed signals are more
difficult to understand due to distortion and are
less pleasant to hear than signals with less
compression.
6 Press [METER] to select the ALC function.
7 The compression level affects the ALC setting for
SSB; therefore, while continuing to speak into the
microphone, adjust the CAR control for a reading
within the ALC zone.
Keep the meter inside the ALC zone for the
cleanest transmit signal and to avoid interfering
with other stations on adjacent frequencies.
Mode
SSB
CW
FSK
AM
FM
Unmixed AF
Keyed output from DSP with sidetone OFF
AF corresponding to the shift and mark/space
Unmixed AF
Unmixed AF
Transmit Sampling Point
dB
+6
+3
0
-3
-6
Lower
Raise
Low
range
High
range
800 Hz 1.6 kHz
50
49
38
27
16
OFF
CAR DELAY
AGC KEY SPEED
METER PROC MONI
0
2
46
8
100
2
46
8
10
MIC
ATT
ANT DOWN UP
VOX FULL/SEMI
AT TUNE
SEND
THRU/AUTO
AIP
PHONES
PROC MONI
MIC PWR
M.IN
REC F.LOCK
CH 4 CLR
CH 3 SCAN
CH 2 M>VFO
CH 1 M.IN
ENTER TF-SET
FINE
1MHz
QUICK MEMO
MR
SLOW FAST
0
2
46
8
10
SWR
PWR
S
9
7
5
3
1
1
0
2
5
50
FILTER
A
LC
3
10 2
1
.5
1
0
2
0
4
0
1
0
0
6
0
W
d
B
d
B
2
0
COMP
M.CH
USB CW R FSK FM AMLSBAUTO
FULLVOX SEMI AIP AGC AUTO PROC MONI
HF TRANSCEIVER TS-870
ON AIR AT TUNE
0
2
46
8
10
PROC
MONI
10
d
B
20
COMP
52


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kenwood TS-870S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kenwood TS-870S in the language / languages: English as an attachment in your email.

The manual is 2,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kenwood TS-870S

Kenwood TS-870S User Manual - Dutch - 102 pages

Kenwood TS-870S User Manual - French - 102 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info