The SKY COMMAND SYSTEM II allows remote control of a TS-990S, TS-2000, TS-2000X, TS-B2000, TS-480HX, TS-480SAT, TS-
570D, TS-570S, TS-590S, or TS-870S HF transceiver.
You will use one transceiver as a control station called “Commander”. The transceiver connected with the HF transceiver is called
“Transporter”. It will function as an interface between the Commander and the HF transceiver. This system allows you, for example, to
watch for and hunt DX while washing your car, or to operate the HF transceiver while relaxing in your car, living room, or patio, instead
of in your shack.
The Commander and Transporter transfer audio and commands as below:
SKY CMD-1
VHF Freq.
UHF Freq.
CONNECTING THE TRANSPORTER WITH THE HF TRANSCEIVER
In order to connect the transporter to the HF transceiver, you need to prepare three cables by yourself. For the connection between the
PC/ COM connectors on the two transceivers, you may use a commercially available RS-232-C cross-wired cable (A D-SUB female/
male conversion adapter is required.)
Note:
◆Operation of SKY COMMAND SYSTEM II may not been permitted in certain countries. Check your local laws before operating.
◆Switch OFF both the Transporter and HF transceiver before making the connection.
◆The Transporter automatically transmits its callsign in Morse at regular intervals because of legal requirements; therefore, transmit side tone must be output from the
HF transceiver.
◆When the Transporter is too close to the HF transceiver, unwanted feedback may cause malfunction.
◆Do not share a regulated power supply between the Transporter and the HF transceiver. Unwanted feedback may cause malfunction.
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Kenwood TM-D710GA at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Kenwood TM-D710GA in the language / languages: English as an attachment in your email.
The manual is 7,22 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
