706647

Kenwood FHM155SI kFlex Manual

14
Zoom out
Zoom in
Previous page
1/218
Next page
11 12
recipes ideas/suggestions
carrot and coriander soup
use the blender
25g butter
50g onion chopped
1 clove garlic crushed
750g carrot cut into 1½ cm cubes
cold chicken stock
10-15mls (2-3tsp) ground coriander
salt and pepper
1 Melt the butter in a pan, add the onion and garlic and fry
until soft.
2 Place the carrot into the blender, add the onion and garlic.
Add sufficient stock to reach the 1.6L level marked on the
goblet. Fit the lid and filler cap.
3 Blend on maximum speed for 5 seconds for a coarse soup
or longer for a finer result.
4 Transfer the mixture to a saucepan, add the coriander and
seasoning and simmer the soup for 30 to 35 minutes or until
cooked.
5 Adjust the seasoning as necessary and add extra liquid if
required.
troubleshooting guide
Problem Cause Solution
The processor will not operate. No Power.
Speed light not lit.
Bowl not fitted to power unit correctly.
Bowl lid not locked on correctly.
Check processor is plugged in.
Check bowl is located correctly and the
handle is situated towards the right hand
side.
Check that the lid interlock is located
correctly into the handle area.
The processor will not work if the bowl and
lid are fitted incorrectly.
Blender will not operate. Blender not locked on correctly.
Blender not assembled correctly.
The blender will not operate if fitted
incorrectly to the interlock.
Check blade unit is fully tightened into the
goblet.
Processor stops or slows during
processing.
Overload protection operated.
Processor overloaded or overheated during
operation.
Maximum capacity exceeded.
Switch off, unplug and allow the appliance
to cool down for approximately 15 minutes.
Refer to the speed chart for maximum
capacities to process.
Weighing function
(----) flashing on screen.
Weight changed on display screen.
Either the ingredients or the bowl/attachment/
lid have been removed and (- - - -) represents
a minus reading.
Quantity weighed too small.
Power unit moved during operation.
Press the ZERO button to reset.
Use teaspoon and tablespoon measures
for very small quantities.
Do not move unit during use.
Zero the display before weighing next
ingredients.
Processor not operating and speed
light flashing.
Appliance left plugged in without operating
for more than 30 minutes.
Lid or bowl removed or unlocked whilst
speed selected.
Press either the ZERO button or turn the
speed control OFF 'O' and then back to
the 'ON' position.
To reset – turn to ‘O’, then turn to ‘ON’
and reselect a speed.
Blender leaking from blade assembly
base.
Seal missing.
Seal incorrectly fitted.
Seal damaged.
Check seal is fitted correctly and not
damaged. To obtain a replacement seal
see “service & customer care”.
Blender seal missing from blade unit
when removed from packaging.
The seal is packed pre-fitted to the blade
unit.
Unscrew goblet and check that seal is
fitted to blade unit.
To obtain a replacement seal see “service
& customer care”.
Poor performance of tools/
attachments.
Refer to hints in relevant “using the attachment” section. Check attachments are assembled
correctly.
… 14 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kenwood FHM155SI kFlex at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kenwood FHM155SI kFlex in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 4,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info