686375

Kemppi Robot Gun Cleaning Station Manual

18
Zoom out
Zoom in
Previous page
1/27
Next page
18
Robot Gun Cleaning Station© Kemppi Oy 2016 1616
OPERATING MANUAL
10.5 Attaching the cutting prism
This section describes how to fasten the cutting prism in
place.
The parts of the system are depicted in the gure below.
Figure 15: Installing the wire-cutting device
1. Clamping prism
2. Mark for gas nozzle Ø
3. Cylinder screw, M8×20
4. Allen key, SW 6
5. Clamping device gas nozzle
Proceed as follows:
1. Mount the clamping prism (1) in the clamping
device (5) from above.
See that a clamping prism (1) that ts the gas nozzle
diameter is mounted. You can nd the diameter of the prism
marked on the prism.
2. Attach the clamping prism with the cylinder screw
(3) (tightening torque: 20 Nm).
10.6 Mounting the milling cutter
This section describes how to mount the milling cutter.
The parts of the system are depicted in the gure below.
Figure 16: Mounting the milling cutter
1. Milling cutter
2. Wrench, SW17
3. Wrench, SW21
4. Compressed-air motor
5. Bellows
6. Motor protection cap
7. Motor output shaft
Use only tools with a suitable width across ats when
replacing the milling cutter. Motor protection cap (6): SW 21;
milling cutter: SW 17.
Ensure that the bellows (5) is in the right position.
Proceed as follows:
1. Mount the motor protection cap (6).
2. Mount the milling cutter (1) on the compressed-air
motor (4).
3. Tighten the milling cutter (1) by means of the
wrench, SW17 (2) (minimum tightening torque: 20
Nm), and hold with a wrench, SW21 (3).
For a better mounting, the compressed-air motor should
be in the lower clamping and stroke position.
Figure 17: Position of the bellows
… 18 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kemppi Robot Gun Cleaning Station at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kemppi Robot Gun Cleaning Station in the language / languages: English as an attachment in your email.

The manual is 2,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info