686409

Kemppi A7 TIG Orbital System 300 Manual

13
Zoom out
Zoom in
Previous page
1/61
Next page
13
A7 TIG Orbital System 300© Kemppi Oy 2016 1615
OPERATING MANUAL
Roller chain and tensioner
Roller chain and tensioner hold the 300-series weld head
on the guide ring. Roller chain changes for each pipe size
and is supplied as part of the guide ring kit with the link
that improves the rigidity of the hinge.
• The roller chain and tensioner assembly circles
the guide ring reaching from the machine
package to the tractor.
• The latch/tensioner mechanism is located at the
tractor end.
• Rollers on the exible chain minimize friction and
facilitate motion around the pipe.
• An integral spring in the tensioner compensates
for expansion of the guide ring caused by
heating.
• Because of the positive drive properties of the
sprocket/chain system, the cylindrical tensioning
collar only requires nger tightening.
2.4 Installing guide ring on tube
1. Manually tack the two pipes together.
2. Install the guide ring with the notched side away
from the weld joint.
3. Locate the guide ring 60 ±1 mm from the centre
of the weld joint.
The guide ring must be parallel to the weld joint
because accurate torch tracking depends on its position.
Mount the guide ring parallel to the weld joint
because accurate torch tracking is dependent upon the
guide ring position. For repetitive welds, do the following:
A. Make an alignment xture to slip over the pipe to
be welded and locate from the pipe bevel.
B. Make the end of the xture square and hold the
guide ring tightly against it.
C. Tighten the guide ring against the pipe.
Drilled holes are provided for removal with a special
pin in special cases; do not use them during normal
installation and removal.
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kemppi A7 TIG Orbital System 300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kemppi A7 TIG Orbital System 300 in the language / languages: English as an attachment in your email.

The manual is 4,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info