686408

Kemppi A7 TIG Orbital System 150 Manual

7
Zoom out
Zoom in
Previous page
1/48
Next page
7
A7 TIG Orbital System 150© Kemppi Oy 2016 1615
OPERATING MANUAL
1.3.2 Collets
Collets are used for clamping the weld head on the tube
or tting to be welded. Collets always come in pairs, and
they are mounted on the hinged collet frame with screws.
Collets are specied by:
• Weld head model
• Outer diameter (OD) of the tube or pipe.
Two types of collets are available: ush and extended.
1.3.3 Collet frame and collets
The collets mount in the weld head and are used to clamp
the head on to the tube or ttings to be welded.
• The collet frame swings open on a hinge and is
held closed using two latches on either side of
the head.
• Both sides of the collet frame open and close
independently.
• This allows one tube (or tting) to be clamped
in place and the second tube (or tting) to be
butted tightly to the rst clamped tube before it
is clamped.
Above function is solely to keep the head from moving
during welding, and it should not be used as a substitute for
external alignment xtures, clamps, or tack welding to hold
the workpieces aligned.
Each collet pair consists of two half-circle pieces that are
mounted on both sides of the hinged collet frame using
screws (see images below).
The collet frame and collets are connected to the work (+)
lead of the torch cable, and a separate return lead is not
needed.
Collet sets must be ordered separately. One weld head
requires two pairs of collets (1 set = two pairs).
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kemppi A7 TIG Orbital System 150 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kemppi A7 TIG Orbital System 150 in the language / languages: English as an attachment in your email.

The manual is 3,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info