686369
27
Zoom out
Zoom in
Previous page
1/66
Next page
27
A7 MIG Welder© Kemppi Oy 2018 1804
INTEGRATION GUIDE
5. SYSTEM CONFIGURATION
This section describes the settings that are typically
made only once or that are otherwise necessary for
integration to be completed successfully. It does not
describe those settings that aect welding quality and are
modied on the basis of the welding operation. For more
information on the operation-based settings, see the A7
MIG Welder operating manual.
Use the web user interface to perform the system
conguration within the integration. Some items necessary
for the integration phase, such as eldbus conguration
parameters, are not available from the setup panel.
5.1 Welding system, sensors and devices
To congure the welding system, go to the Welding
settings > Welding system.
5.1.1 General settings
Water cooling
Set the water cooling in accordance with your system
conguration:
Choose OFF for a gas-cooled system
Choose ON for lling up the cooling system
Choose AUTO for normal operation with a water-
cooled system
Welding cable length
Set the welding cable length in meters. The cable length
includes the welding (-) and welding (+) cables.
Example:
Welding (-) clamp cable length 10 m
Interconnection cable set length 10 m
Torch cable set length 2 m
Total welding cable length 22 m
5.1.2 Wire feed settings
Wire feeder
Select the wire feeder you are using. This setting has eect
only in systems with dual wire feeder support:
Choose WIRE FEEDER 1 for the primary wire
feeder
Choose WIRE FEEDER 2 for the secondary wire
feeder
Choose SELECT AT ROBOT to manage the wire
feeder selection from the robot pendant.
This feature requires the dual wire feeder extension kit
installed. That kit is available separately and is not included
in the standard package.
Wire feed motor current warning level
Set the wire feeder motor warning level to match the
wire liner length, wire diameter, and other parameters
aecting the load on the wire feeder motors. The initial
value is 3.5 A. The system issues a warning when the long-
term average current exceeds the warning threshold.
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kemppi A7 MIG Welder 350 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kemppi A7 MIG Welder 350 in the language / languages: English as an attachment in your email.

The manual is 5,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info