686369
15
Zoom out
Zoom in
Previous page
1/66
Next page
15
A7 MIG Welder© Kemppi Oy 2018 1804
INTEGRATION GUIDE
3.12 Touch sensor status fast output
This welding system is equipped with an instantly
responding touch-sensing feature for locating the work-
piece in teaching of the welding robot.
In normal operation, the status of the touch sensor is
passed to the robot via a eldbus connection. However,
eldbus bus latency aects the eciency of operation. To
avoid delays, the hardware-based fast output can be used
for better response. For connection of fast status output,
the robot must have at least one hardware input available.
Connect the fast output to the touch sensor fast status
output connector on the rear of the robot interface unit by
using a custom cable. Connect the other end of the cable
to the hardware input of the robot controller.
A
B C
Figure 3.16: Fast status output connector
A. Supply in +24 V
B. Status signal out
C. Supply GND
The fast output requires an external 18–36 V power
supply.
The output is galvanically isolated from other
hardware and is short-circuit-protected. The maximum
continuous switching current is 100 mA @ +24 V.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kemppi A7 MIG Welder 350 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kemppi A7 MIG Welder 350 in the language / languages: English as an attachment in your email.

The manual is 5,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info