686368
43
Zoom out
Zoom in
Previous page
1/67
Next page
43
A7 MIG Welder© Kemppi Oy 2018 1824
OPERATING MANUAL
Fieldbus
1
9
2
10
3
8
4
7
5
6
Figure 4.20 Touch sensing system
1. Conguration (web user interface or setup panel)
2. Welding plus (welding wire touch sensing)
3. Wire feeder control cable (gas nozzle touch sensing)
4. Fast status (direct hardware connection, optional)
5. Fieldbus / Digital robot interface
6. Arc measurement cables
7. Peripheral connector
8. Touch tool (welding wire or gas nozzle)
9. Touch detection
10. Welding minus (touch sensor ground)
On/O control
The touch sensor device behaves as a software controllable power
source. The power source can be switched on and o from the robot
controller by using the digital robot interface. The touch sensor cannot
be put on or turned o from the setup panel or the web user interface.
The touch sensor cannot be used when the welding cycle is on.
43


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kemppi A7 MIG Power Source 450 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kemppi A7 MIG Power Source 450 in the language / languages: English as an attachment in your email.

The manual is 3,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info