686368

Kemppi A7 MIG Power Source 450 Manual

30
Zoom out
Zoom in
Previous page
1/67
Next page
30
A7 MIG Welder© Kemppi Oy 2018 1824
OPERATING MANUAL
4.3.1 Welding display
Figure 4.3 Welding display, main view
The Welding display view monitors the selected memory
channel, the welding process data and the robot control
state in real time. The display shows welding current,
voltage, power, wire feed speed and gas ow rate. If arc
measurement is set on, the measured arc voltage and arc
power are also displayed.
You can view and change the welding parameters of
the current memory channel by clicking on the memory
channel info bar.
Figure 4.4 Welding display – editing welding parameters
Clicking on the memory channel info bar opens a sub view
where you can change wire feed speed and, depending
on the process, the ne tuning, voltage, dynamics, pulse
current, double pulse amplitude and double pulse
frequency values during welding. Saving the changes will
aect the arc behavior immediately.
4.3.2 Gas, air and wire inch
Figure 4.5 Gas, air and wire inch view
In the Gas, air and wire inch view you can test shielding
gas valve, compressed air valve, wire inch and wire retract.
To adjust the duration of the gas and air test, use the
slider bars. Then click on the Run gas or Run air button.
The test stops automatically after the specied time.
Clicking the test button again during the test stops the
test immediately.
To adjust the wire feed speed for wire inch and wire retract
use the slider bar. Then click either on Run wire backward
or Run wire forward button to start the test. The button
has to be kept pressed down throughout the whole test.
Releasing the button stops the test.
… 30 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kemppi A7 MIG Power Source 450 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kemppi A7 MIG Power Source 450 in the language / languages: English as an attachment in your email.

The manual is 3,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info