686376

Kemppi A3 MIG Power Source 400 Manual

25
Zoom out
Zoom in
Previous page
1/32
Next page
25
A3 MIG Welder© Kemppi Oy 2018 1826
OPERATING MANUAL
4.9 Collision sensor
For information on connecting and conguring the
collision sensor, see the A3 MIG Welder Integration guide.
The collision sensor is a module mounted between a ro-
bot arm and a welding torch. It protects the torch neck
from bending and breaking on a collision to an obstacle.
The collision detection is usually based on micro switches
or optical switches which act on the collision. The detec-
tion is passed to the robot that uses it to stop motion im-
mediately to prevent any damage.
In the A3 MIG Welder the collision sensor signal is read by
the power source, and the information is passed to the ro-
bot by the welding system. In addition, a collision causes
always the Error 146 Collision detected in the welding
system. When the error occurs, the power source stops
welding immediately.
Fieldbus
1
2
3
5
4
Figure 4.7 Collision sensing system
1. Collision sensor
2. Fieldbus / Digital robot interface
3. Wire feeder control cable
4. Peripheral connector
5. Conguration using DIP switches
The collision sensor is mounted to the robot arm, and it is
a mounting point for the welding torch.
2
3
4
5
1
Figure 4.8: Collision sensor mounting
1. Robot arm
2. Collision sensor
3. Collision signal cable
4. Torch suspension
5. Torch neck
There is a 7-pin peripheral connector in the front panel
of the wire feeder. The collision sensor signal is available
in the pin B, and the supply for the signal is in the pin A.
See the A3 MIG Welder Integration guide for more details.
… 25 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kemppi A3 MIG Power Source 400 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kemppi A3 MIG Power Source 400 in the language / languages: English as an attachment in your email.

The manual is 6,03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info