686376

Kemppi A3 MIG Power Source 400 Manual

11
Zoom out
Zoom in
Previous page
1/32
Next page
11
A3 MIG Welder© Kemppi Oy 2018 1826
OPERATING MANUAL
4. USING THE WELDER
4.1 Basic controls
Main switch
When you turn the on/o switch to position 1, the main
power indicator is illuminated, and the welding system
starts a power-up sequence. The system is ready for use
when the control panel is ready. Always turn the machine
on and o with the power source mains switch. Never use
the mains plug as a switch.
Indicator lights
The indicator lights of the machine report its operational
state: When the green main power indicator is on, it indi-
cates that the machine is switched on. When the orange
warning indicator light is on, the machine is overheated.
This is due to a higher than regular working load exceed-
ing the rated duty cycle. The cooling fan continues to cool
the machine down. When the light goes o the machine
is ready to weld again.
Cooling fans
The A3 Power Source incorporates two simultaneously
operating cooling fans. The fans will start during weld-
ing as the machine reaches operational temperature, and
they will run for 1 to 10 minutes after welding, depending
on the heat eect of the completed cycle.
4.2 Control panel
31 2 4
9 10 1187
6
5
1
2
21
Figure 4.1 Control panel buttons, displays and knobs
1. Left display
2. Right display
1. Left selection/adjustment knob
2. Right selection/adjustment knob
1. Escape/Back button
2. Dynamics button
3. Gas test button
4. Wire inch button
5. System setup button
6. Synergic program selection button
7. Welding process selection button
8. Synergic feature setup button
9. Memory channel edit mode selection
button
10. Memory channel selection button
11. Memory channel save button
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kemppi A3 MIG Power Source 400 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kemppi A3 MIG Power Source 400 in the language / languages: English as an attachment in your email.

The manual is 6,03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info