738045
10
Zoom out
Zoom in
Previous page
1/24
Next page
M3i lite INDOOR GROUP CYCLE 10
HOW TO ASSEMBLE THE BIKE
Prepare Base and Main Frame.
(a) Release the Computer Display from the packing
material and remove the Mount Screw using a #2 Phillips
Screwdriver.
(b) Coil the Communication Wire into the Computer
Mount Cavity. Avoid pulling/pinching the wire.
(a) Remove the two Handlebar Screws from the Post
using a 6 mm Allen Wrench.
(b) Place the Handlebar onto the Post as shown, with
the mounting holes aligned.
(c) Start each Screw into the mounting holes by pressing
down at the center of the Handlebar with one hand; this
will set the Handlebar evenly onto the Post. With your
other hand, tighten each Screw evenly until tight.
(c) Slide the Computer Mount
up and under the Mount
Tabs. Align the screw holes
and install the Mount Screw
(removed in Step 3) using a
#2 Phillips Screwdriver.
Pull x3 Caps
off Base Studs
1
3
(a) Position the front of the Main Frame facing the
Transport Wheels, then carefully lower the Main Frame
onto the Base over the Base Studs.
(b) Install one Washer and one Acorn Nut (Items B and A)
onto each Base Stud. Tighten Acorn Nuts using a 16 mm
(5/8 inch) Open-end Wrench. Torque to 35 ft-lbs (47 Nm)
using a 16 mm (5/8 inch) Crowfoot and Torque Wrench.
2
4
REAR
FRONT
Transport Wheels
Mount
Screw
Mount
Screw
Computer
Display
A
B
Coil
Communication
Wire
Mount
Tabs
Handlebar
Handlebar Screws
Post
If present, release Shipping
Board from Main Frame
(Tool: 1/2-inch Wrench)
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Keiser M3i lite Indoor Group Cycle at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Keiser M3i lite Indoor Group Cycle in the language / languages: English as an attachment in your email.

The manual is 8,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info