738047

Keiser 3010XP Performance Trainer Manual

15
Zoom out
Zoom in
Previous page
1/20
Next page
OPERATION MANUAL
PERFORMANCE TRAINER
15
Do not operate the equipment during battery replacement procedure. “Lo-bA” = Batteries are low, replace immediately.
NOTE: If batteries are dead (depleted), the Power Display remains blank. To replace the batteries, refer to Figure 10 and
follow the instructions below.
BATTERY REPLACEMENT
Figure 10. Battery Replacement
When the batteries are replaced, the Power Display will run through a test sequence (you will see a series of numbers ashing).
Once the test sequence stops and the Power Display shows "OFF," the Performance Trainer is ready for use.
Do not dispose of batteries in a re. The
batteries may explode.
Do not open or mutilate batteries. They
contain an electrolyte which is toxic and
harmful to the skin and eyes.
Replace batteries with the same number
and type of batteries as originally installed
in the equipment.
Recycle batteries in accordance with local
recycling procedures.
CAUTION
Tools Required:
#3 Phillips screwdriver
PROCEDURE:
1. Open the Performance Trainer by removing
the ve Phillips Screws along the left side.
2. Locate the Processor Box at the base. Unscrew
the brass nut to remove cover.
3. Remove the two D batteries by carefully pulling
out the battery sleeve (follow manufacturer’s
recommendations for handling, maintaining,
and disposing of batteries).
4. Observe the correct polarity position (see +/-
marking on the circuit board), insert the two
new D batteries into the battery sleeve and
install.
5. Replace the Processor Box cover and screw
the brass nut nger tight.
6. IMPORTANT: Avoid pinching the Air Line.
Route the Air Line along the notch at the base.
Close the Performance Trainer, align all screw
holes and fasten with the screws removed in
Step 1.
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Keiser 3010XP Performance Trainer at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Keiser 3010XP Performance Trainer in the language / languages: English as an attachment in your email.

The manual is 11,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info