771572
42
Zoom out
Zoom in
Previous page
1/84
Next page
Preliminary checks Yes / No
1 The flooring must be able to support the weight of the unit when full with water (see
dimensional)
2 Unit installed inside, in a vertical position and sheltered from freezing temperatures.
3 The site location must be free from any corrosive elements in the atmosphere such as sulfur,
fluorine, and chlorine and dust in excessive quantities.
4
Sufficient air flow for the unit to function.
The unit must be located in a space >15m³, and must have unrestricted air flow.
The unit cannot be placed into any type of closet or small enclosure.
5 Sufficient room to maintenance the unit.
6 All piping properly installed and free of leaks.
7 Filter for water coming from water mains present and accessible for maintenance
8 Condensate drain pipe connected and conveyed to an adequate drain, protected from frost
9 DHW safety valve pipe connected and conveyed to an adequate drain, protected from frost
10 Water temperature limit valve or mixer tap (recommended) installed per manufacturers instructions.
11 Hydraulic system filled, pressurised and drained
12 Sufficient inlet water pressure, between 1,5 Bar ~ 6,5 Bar (0,15 MPa ~ 0,65 MPa) (1,5Bar)
(0,15MPa)
13 Expansion tank checked / filled with nitrogen
14 The unit and electrical system are properly grounded.
15 Present overload protection / differential switch.
16 Power supply and connections cables comply with national standards and the requirements of this
manual.
17 Power supply voltage within the limits: 220-240Vac
18
The external air temperature within the limits: above -7ºC and below 43ºC
If the externalair temperature falls outside these upper and lower limits the electrical elements will
be activated to meet the hot water demand
9 START-UP
42


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kaysun Solar Compak KHPA2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kaysun Solar Compak KHPA2 in the language / languages: English as an attachment in your email.

The manual is 9.67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info