771570
22
Zoom out
Zoom in
Previous page
1/48
Next page
7 - INSTALLATION AND START UP
Two tubes arranged together
fig. 9
7.8.3 Insulating the refrigerant tubing (fig. 9)
Thermal insulation should be applied to all pipes in the unit, including connection points.
For the gas line use insulating agents resistant to at least 120°C or higher temperatures; for all other pipes, a resistance
of up to 80°C is sufficient.
The thickness of the insulation must be at least 10mm or higher. Increase the thickness if the thermoigrometric
conditions inside the pipe passage cavity exceed 30°C b.s. - 70% u.r. Also isolate flare connections by creating an
insulating sleeve of thickness equivalent to that of the pipeline, fixing it with a special tape.
Flare insulator
Insulation tape (white)
Flare union
Unit side
Flare nut Tube insulator
(not supplied)
Heat resistant
Insulation
Liquid tubing Gas tubing
7.8.2 Welding joint cautions
Replace air inside the tube with nitrogen gas to prevent copper oxide film from forming during the brazing process.
(Oxygen, carbon dioxide and Freon are not acceptable.)
Use a reducing valve for the nitrogen cylinder.
Do not allow the tubing to get too hot during brazing. The nitrogen gas inside the tubing may overheat, causing
refrigerant system valves to become damaged. Therefore allow the tubing to cool when brazing.
Do not use agents intended to prevent the formation of oxide film. These agents adversely affect the refrigerant and
refrigerant oil, and may cause damage or malfunctions.
Repeat the previous procedures for the second connection.
pag. 22
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kaysun KRE-2300DX1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kaysun KRE-2300DX1 in the language / languages: English as an attachment in your email.

The manual is 3.62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info