424422
14
Zoom out
Zoom in
Previous page
1/80
Next page
Connection and Start-up
14
Connection and Start-up
The following section is specifically intended for the specialist dealer.
You only need to read this section, if you are carrying out the installa-
tion yourself.
You will find sample configurations in the section "Connection exam-
ple".
First, carry out all installation work before connecting the receiver to
the mains power supply.
Refer to the information provided in the section "Safety instructions“.
Connecting receiver
Sat-IF connection
Connect the Sat-IF input of the receiver to the satellite receiving sys-
tem (satellite dish).
Use a coaxial cable with a standard F connector for this purpose.
If you need to fit the F-connector onto the cable, strip the cable insula-
tion as shown in the diagram and slide the F-connector onto the ca-
ble, then carefully turn it clockwise until it locks.
When fitting the connector, make sure that no wires of the shield braid
make contact with the inner conductor. This could otherwise cause a
short-circuit.
The quality of the reception signal depends on a good connection!
Preconditions for receiving signals
Make sure that your satellite antenna system is equipped with at least
one universal LNB to facilitate digital reception in the high band range.
Presetting of receiving system
The control signals for conventional receiving systems (satellite
dishes) are preset, i.e. 14/18 V for polarisation changeover and 22
kHz switching signal for LOW/HIGH band changeover on multifeed re-
ception systems.
The presetting will need to be changed in the installation menu, menu
item "DiSEqC," if UFOmicro or tone burst switching matrices are used
in the receiving system.
Refer to the section "Installation menu, DiSEqC menu“ for this pur-
pose.
It is important, that you observe the operating manual for the used ma-
trix.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kathrein ufd 540 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kathrein ufd 540 in the language / languages: English as an attachment in your email.

The manual is 3,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kathrein ufd 540

Kathrein ufd 540 User Manual - German - 80 pages

Kathrein ufd 540 User Manual - French - 80 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info