629516
8
Zoom out
Zoom in
Previous page
1/80
Next page
Connection and Setup
8
The following section is intended specifi cally for specialist
dealers. You only need to pay attention to this section if you are
carrying out the installation yourself.
The
Connection diagram
section contains a sample
confi guration.
Do not connect the unit to the mains until all installation work
has been properly carried out. Refer to the information in the
Safety instructions
section.
Connecting the Unit
Connect the SAT-IF input on the UFD 170 to the satellite receiving sys-
tem. Use a coaxial cable with a standard F connector.
If the F connector is not yet tted on the cable, strip the insulation from
the cable as shown in the following illustration and carefully twist the
F connector onto the end of the cable until it is securely tted on the
cable.
When tting the connector, make sure that no wires from the braiding
are touching the inner conductor - this could result in short circuit.
The quality of the reception signal depends on the connection.
SAT-IF Connection
Receiving Requirements
Receiving System Presets
Make sure that your own satellite antenna system is equipped with at
least a universal LNB for digital reception in the high-band range.
The presents for the control signals have been made for standard
reception systems, i.e. 14/18 V for polarity reversal and 22 kHz
switching signal for low/high band changeover on multi-feed reception
systems.
7 mm
10 mm
If you will be using the UFD 170 in conjunction with a CAP 210 or
CAP 310 from Kathrein, the installation instructions for the relevant
CAP unit must be followed during installation.
braid bent back
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kathrein UFD 170 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kathrein UFD 170 in the language / languages: English as an attachment in your email.

The manual is 5,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info